ONLYOFFICE all versions as of 2021-11-08 is affected by Incorrect Access Control. An authentication bypass in the document editor allows attackers to edit documents without authentication.

The Noise protocol implementation suffers from weakened cryptographic security after encrypting 2^64 messages, and a potential denial of service attack. After 2^64 (~18.4 quintillion) messages are encrypted with the Encrypt function, the nonce counter will wrap around, causing multiple messages to be encrypted with the same key and nonce. In a separate issue, the Decrypt function increments the nonce state even when it fails to decrypt a message. If an attacker can provide an invalid input to the Decrypt function, this will cause the nonce state to desynchronize between the peers, resulting in a failure to encrypt all subsequent messages.

Tad Uploader edit book list function is vulnerable to authorization bypass, thus remote attackers can use the function to amend the folder names in the book list without logging in.

ESPHome is a system to control the ESP8266/ESP32. Anyone with web_server enabled and HTTP basic auth configured on version 2021.9.1 or older is vulnerable to an issue in which `web_server` allows over-the-air (OTA) updates without checking user defined basic auth username & password. This issue is patched in version 2021.9.2. As a workaround, one may disable or remove `web_server`.

On iSmartAlarm cube devices, there is Incorrect Access Control because a "new key" is transmitted in cleartext.

A vulnerability, which was classified as problematic, was found in TOTOLINK A3700R 9.1.2u.5822_B20200513. Affected is an unknown function of the file /wizard.html of the component Password Reset Handler. The manipulation leads to improper access controls. It is possible to launch the attack remotely. The exploit has been disclosed to the public and may be used. The identifier of this vulnerability is VDB-272568. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.

FreeSWITCH is a Software Defined Telecom Stack enabling the digital transformation from proprietary telecom switches to a software implementation that runs on any commodity hardware. Prior to version 1.10.7, FreeSWITCH does not authenticate SIP MESSAGE requests, leading to spam and message spoofing. By default, SIP requests of the type MESSAGE (RFC 3428) are not authenticated in the affected versions of FreeSWITCH. MESSAGE requests are relayed to SIP user agents registered with the FreeSWITCH server without requiring any authentication. Although this behaviour can be changed by setting the `auth-messages` parameter to `true`, it is not the default setting. Abuse of this security issue allows attackers to send SIP MESSAGE messages to any SIP user agent that is registered with the server without requiring authentication. Additionally, since no authentication is required, chat messages can be spoofed to appear to come from trusted entities. Therefore, abuse can lead to spam and enable social engineering, phishing and similar attacks. This issue is patched in version 1.10.7. Maintainers recommend that this SIP message type is authenticated by default so that FreeSWITCH administrators do not need to be explicitly set the `auth-messages` parameter. When following such a recommendation, a new parameter can be introduced to explicitly disable authentication.

Exploitation of Authentication vulnerability in the web interface in McAfee Advanced Threat Defense (ATD) 3.10, 3.8, 3.6, 3.4 allows remote unauthenticated users / remote attackers to bypass ATD detection via loose enforcement of authentication and authorization.

There is an arbitrary password modification vulnerability in a D-LINK DSL-2888A router product. An attacker can use this vulnerability to modify the password of the admin user without authorization.

Incorrect access control in AMAG Symmetry Door Edge Network Controllers (EN-1DBC Boot App 23611 03.60 and STD App 23603 03.60; EN-2DBC Boot App 24451 01.00 and STD App 2461 01.00) enables remote attackers to execute door controller commands (e.g., lock, unlock, add ID card value) by sending unauthenticated requests to the affected devices via Serial over TCP/IP, as demonstrated by a Ud command.

LS ELECTRIC XBC-DN32U with operating system version 01.80 is missing authentication to perform critical functions to the PLC. This could allow an attacker to change the PLC's mode arbitrarily.

An issue was discovered in Emote Remote Mouse through 4.0.0.0. Attackers can maximize or minimize the window of a running process by sending the process name in a crafted packet. This information is sent in cleartext and is not protected by any authentication logic.

An issue was discovered in Couchbase Server before 7.0.4. The Index Service does not enforce authentication for TCP/TLS servers.

A CWE-306: Missing Authentication for Critical Function vulnerability exists that could cause deletion of arbitrary files in the context of the user running IGSS due to lack of validation of network messages. Affected Product: Interactive Graphical SCADA System Data Collector (dc.exe) (V15.0.0.21320 and prior)

A CWE-306: Missing Authentication for Critical Function vulnerability exists that could allow modifications of the touch configurations in an unauthorized manner when an attacker attempts to modify the touch configurations. Affected Product: spaceLYnk (V2.6.2 and prior), Wiser for KNX (formerly homeLYnk) (V2.6.2 and prior), fellerLYnk (V2.6.2 and prior)

IBM Guardium Data Encryption (GDE) 3.0.0.2 and 4.0.0.4 does not perform any authentication for functionality that requires a provable user identity or consumes a significant amount of resources.

Missing Authentication for Critical Function in Icegram Email Subscribers & Newsletters Plugin for WordPress prior to version 4.5.6 allows a remote, unauthenticated attacker to conduct unauthenticated email forgery/spoofing.