Buffer Overflow vulnerability in D-Link DSR-150, DSR-150N, DSR-250, DSR-250N, DSR-500N, DSR-1000N from 3.13 to 3.17B901C allows unauthenticated users to execute remote code execution.

D-Link DSL-3782 v1.01 is vulnerable to Buffer Overflow in /New_GUI/ParentalControl.asp.

D-Link DIR-822 Rev.Bx devices with firmware v.202KRb06 and older allow a buffer overflow via long MacAddress data in a /HNAP1/SetClientInfo HNAP protocol message, which is mishandled in /usr/sbin/udhcpd during reading of the /var/servd/LAN-1-udhcpd.conf file.

D-LINK DI-8003 v16.07.16A1 was discovered to contain a buffer overflow via the fn parameter in the tgfile_htm function.

D-LINK DI-8003 v16.07.26A1 was discovered to contain a buffer overflow via the ip parameter in the ip_position_asp function.

D-LINK DI-8003 v16.07.16A1 was discovered to contain a buffer overflow via the notify parameter in the arp_sys_asp function.

A vulnerability was discovered in DI_8200-16.07.26A1, There is a buffer overflow in the dbsrv_asp function; The strcpy function is executed without checking the length of the string, leading to a buffer overflow.

D-Link DSL-3782 EU v1.01:EU v1.03 is affected by a buffer overflow which can cause a denial of service. This vulnerability exists in the web interface "/cgi-bin/New_GUI/Igmp.asp". Authenticated remote attackers can trigger this vulnerability by sending a long string in parameter 'igmpsnoopEnable' via an HTTP request.

In D-Link DIR-860L v2.03, there is a buffer overflow vulnerability due to the lack of length verification for the SID field in gena.cgi. Attackers who successfully exploit this vulnerability can cause the remote target device to crash or execute arbitrary commands.

Certain D-Link products are affected by: Buffer Overflow. This affects DIR-880L 1.08B04 and DIR-895 L/R 1.13b03. The impact is: execute arbitrary code (remote). The component is: htdocs/fileaccess.cgi. The attack vector is: A crafted HTTP request handled by fileacces.cgi could allow an attacker to mount a ROP attack: if the HTTP header field CONTENT_TYPE starts with ''boundary=' followed by more than 256 characters, a buffer overflow would be triggered, potentially causing code execution.

A buffer overflow in D-Link DIR-615 C2 3.03WW. The ping_ipaddr parameter in ping_response.cgi POST request allows an attacker to crash the webserver and might even gain remote code execution.

A Stack overflow vulnerability in D-Link DCS-932L REVB_FIRMWARE_2.18.01 allows attackers to cause a Denial of Service (DoS) via a crafted HTTP request.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the CurrentPassword parameter in the CheckPasswdSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the MacAddress parameter in the SetWanSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

This vulnerability allows network-adjacent attackers to execute arbitrary code on affected installations of D-Link DAP-1330 1.13B01 BETA routers. Authentication is not required to exploit this vulnerability. The specific flaw exists within the handling of the HNAP_AUTH HTTP header. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a fixed-length buffer. An attacker can leverage this vulnerability to execute code in the context of the device. Was ZDI-CAN-12065.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the GuardInt parameter in the SetWLanRadioSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

This vulnerability allows network-adjacent attackers to execute arbitrary code on affected installations of D-Link DAP-1330 1.13B01 BETA routers. Authentication is not required to exploit this vulnerability. The specific flaw exists within the handling of the SOAPAction HTTP header. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a fixed-length buffer. An attacker can leverage this vulnerability to execute code in the context of the device. Was ZDI-CAN-12066.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the Mac parameter in the SetParentsControlInfo function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the TXPower parameter in the SetWLanRadioSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

D-Link DCS-5220 devices have a buffer overflow. NOTE: This vulnerability only affects products that are no longer supported by the maintainer

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the Encryption parameter in the SetWLanRadioSecurity function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

A buffer overflow vulnerability in /bin/boa on D-Link DIR-619L Rev.B 2.06B1 via formWlanGuestSetup allows remote authenticated users to trigger a denial of service (DoS) through the parameter "webpage."

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the Password parameter in the SetWanSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

A buffer overflow vulnerability in /bin/boa on D-Link DIR-619L Rev.B 2.06B1 via goform/formWPS, allows remote authenticated users to trigger a denial of service (DoS) through the parameter "webpage."

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the SSID parameter in the SetWLanRadioSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the AdminPassword parameter in the SetDeviceSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

** UNSUPPORTED WHEN ASSIGNED ** A vulnerability, which was classified as critical, has been found in D-Link DIR-600M C1 3.08. Affected by this issue is some unknown functionality of the component Telnet Service. The manipulation of the argument username leads to buffer overflow. The attack may be launched remotely. The exploit has been disclosed to the public and may be used. The identifier of this vulnerability is VDB-254576. NOTE: This vulnerability only affects products that are no longer supported by the maintainer. NOTE: Vendor was contacted early and confirmed immediately that the product is end-of-life. It should be retired and replaced.

A vulnerability was found in D-Link DIR-605L 2.13B01. It has been declared as critical. This vulnerability affects the function formSetPortTr of the file /goform/formSetPortTr. The manipulation of the argument curTime leads to buffer overflow. The attack can be initiated remotely. The exploit has been disclosed to the public and may be used.

A vulnerability was found in D-Link DIR-605L 2.13B01. It has been classified as critical. This affects the function formResetStatistic of the file /goform/formResetStatistic. The manipulation of the argument curTime leads to buffer overflow. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used.

D-Link DAP-2660 v1.13 was discovered to contain a buffer overflow via the f_ipv6_enable parameter at /bsc_ipv6. This vulnerability is exploited via a crafted POST request.

D-Link DIR-880 A1_FW107WWb08 was discovered to contain a buffer overflow via the function FUN_0001be68.

D-Link DIR-868L fw_revA_1-12_eu_multi_20170316 was discovered to contain a buffer overflow via the param_2 parameter in the inet_ntoa() function.

D-Link DIR-880 A1_FW107WWb08 was discovered to contain a buffer overflow via the function fgets.

A vulnerability, which was classified as critical, was found in D-Link DIR-619L B1 2.06. Affected is the function formSetMACFilter of the file /goform/formSetMACFilter. The manipulation of the argument curTime leads to buffer overflow. The exploit has been disclosed to the public and may be used.

A vulnerability classified as critical has been found in D-Link DIR-513 1.10. This affects the function formSetWanPPTPcallback of the file /goform/formSetWanPPTPpath of the component HTTP POST Request Handler. The manipulation of the argument curTime leads to buffer overflow. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. This vulnerability only affects products that are no longer supported by the maintainer.

** UNSUPPORTED WHEN ASSIGNED ** A vulnerability has been found in D-Link DNS-120, DNR-202L, DNS-315L, DNS-320, DNS-320L, DNS-320LW, DNS-321, DNR-322L, DNS-323, DNS-325, DNS-326, DNS-327L, DNR-326, DNS-340L, DNS-343, DNS-345, DNS-726-4, DNS-1100-4, DNS-1200-05 and DNS-1550-04 up to 20240814 and classified as critical. Affected by this vulnerability is the function cgi_get_cooliris of the file /cgi-bin/photocenter_mgr.cgi. The manipulation of the argument path leads to buffer overflow. The attack can be launched remotely. The exploit has been disclosed to the public and may be used. NOTE: This vulnerability only affects products that are no longer supported by the maintainer. NOTE: Vendor was contacted early and confirmed that the product is end-of-life. It should be retired and replaced.

A vulnerability was found in D-Link DIR-513 1.10. It has been rated as critical. Affected by this issue is the function websAspInit of the file /goform/formSetWanPPPoE. The manipulation of the argument curTime leads to buffer overflow. The attack may be launched remotely. The exploit has been disclosed to the public and may be used. This vulnerability only affects products that are no longer supported by the maintainer.

A vulnerability classified as critical has been found in D-Link DIR-513 1.0. This affects an unknown part of the file /goform/formSetWanPPTP. The manipulation of the argument curTime leads to buffer overflow. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. This vulnerability only affects products that are no longer supported by the maintainer.

A vulnerability was found in D-Link DI-8100 16.07.21. It has been rated as critical. Affected by this issue is some unknown functionality of the file /pppoe_base.asp of the component jhttpd. The manipulation of the argument mschap_en leads to buffer overflow. The attack may be launched remotely. The exploit has been disclosed to the public and may be used.

D-Link DIR-823G firmware version 1.02B05 has a buffer overflow vulnerability, which originates from the HostName field in SetParentsControlInfo.

D-Link DIR-619L 2.06B01 is vulnerable to Buffer Overflow in the formLanguageChange function via the nextPage parameter.

D-Link DIR-619L 2.06B01 is vulnerable to Buffer Overflow in the formWlanSetup function via the parameter f_wds_wepKey.

D-Link DIR-619L 2.06B01 is vulnerable to Buffer Overflow in the formSysCmd function via the submit-url parameter.

D-Link DIR-868L Hardware version A1, firmware version 1.12 is vulnerable to Buffer Overflow. The vulnerability is in scandir.sgi binary.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the EndTime parameter in the SetParentsControlInfo function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

D-Link DIR-823G A1V1.0.2B05 was discovered to contain a buffer overflow via the Type parameter in the SetWLanRadioSettings function. This vulnerability allows attackers to cause a Denial of Service (DoS) via a crafted input.

A Buffer overflow vulnerability in D-Link DAP-2555 REVA_FIRMWARE_1.20 allows remote attackers to cause a Denial of Service (DoS) via a crafted HTTP request.

Buffer Overflow Vulnerability in D-Link DIR-825 v1.33.0.44ebdd4-embedded and below allows attacker to execute arbitrary code via the GetConfig method to the /CPE endpoint.

D-Link DIR3060 DIR3060A1_FW111B04.bin is vulnerable to Buffer Overflow.

D-Link Go-RT-AC750 GORTAC750_revA_v101b03 and GO-RT-AC750_revB_FWv200b02 are vulnerable to Buffer Overflow via cgibin, hnap_main,