Pairing in Bluetooth® Core v5.2 and earlier may permit an unauthenticated attacker to acquire credentials with two pairing devices via adjacent access when the unauthenticated user initiates different pairing methods in each peer device and an end-user erroneously completes both pairing procedures with the MITM using the confirmation number of one peer as the passkey of the other. An adjacent, unauthenticated attacker could be able to initiate any Bluetooth operation on either attacked device exposed by the enabled Bluetooth profiles. This exposure may be limited when the user must authorize certain access explicitly, but so long as a user assumes that it is the intended remote device requesting permissions, device-local protections may be weakened.

Switchboard Bluetooth Plug for elementary OS from version 2.3.0 and before version version 2.3.5 has an incorrect authorization vulnerability. When the Bluetooth plug is running (in discoverable mode), Bluetooth service requests and pairing requests are automatically accepted, allowing physically proximate attackers to pair with a device running an affected version of switchboard-plug-bluetooth without the active consent of the user. By default, elementary OS doesn't expose any services via Bluetooth that allow information to be extracted by paired Bluetooth devices. However, if such services (i.e. contact list sharing software) have been installed, it's possible that attackers have been able to extract data from such services without authorization. If no such services have been installed, attackers are only able to pair with a device running an affected version without authorization and then play audio out of the device or possibly present a HID device (keyboard, mouse, etc...) to control the device. As such, users should check the list of trusted/paired devices and remove any that are not 100% confirmed to be genuine. This is fixed in version 2.3.5. To reduce the likelihood of this vulnerability on an unpatched version, only open the Bluetooth plug for short intervals when absolutely necessary and preferably not in crowded public areas. To mitigate the risk entirely with unpatched versions, do not open the Bluetooth plug within switchboard at all, and use a different method for pairing devices if necessary (e.g. `bluetoothctl` CLI).

IBM Spectrum Protect Operations Center 8.1.0.000 through 8.1.10.and 7.1.0.000 through 7.1.11 could allow a remote attacker to obtain sensitive information, caused by improper authentication of a websocket endpoint. By using known tools to subscribe to the websocket event stream, an attacker could exploit this vulnerability to obtain sensitive information. IBM X-Force ID: 188993.

The SSH USERAUTH CHANGE REQUEST feature in SSH Tectia Server 6.0.4 through 6.0.20, 6.1.0 through 6.1.12, 6.2.0 through 6.2.5, and 6.3.0 through 6.3.2 on UNIX and Linux, when old-style password authentication is enabled, allows remote attackers to bypass authentication via a crafted session involving entry of blank passwords, as demonstrated by a root login session from a modified OpenSSH client with an added input_userauth_passwd_changereq call in sshconnect2.c.

In Mosquitto before 1.4.12, pattern based ACLs can be bypassed by clients that set their username/client id to '#' or '+'. This allows locally or remotely connected clients to access MQTT topics that they do have the rights to. The same issue may be present in third party authentication/access control plugins for Mosquitto.

PostgreSQL versions before 9.2.22, 9.3.18, 9.4.13, 9.5.8 and 9.6.4 are vulnerable to incorrect authentication flaw allowing remote attackers to gain access to database accounts with an empty password.

denyhosts 2.6 uses an incorrect regular expression when analyzing authentication logs, which allows remote attackers to cause a denial of service (incorrect block of IP addresses) via crafted login names.

IBM Spectrum Protect Client 8.1.7.0 through 8.1.9.1 (Linux and Windows), 8.1.9.0 trough 8.1.9.1 (AIX) and IBM Spectrum Protect for Space Management 8.1.7.0 through 8.1.9.1 (Linux), 8.1.9.0 through 8.1.9.1 (AIX) web user interfaces could allow an attacker to bypass authentication due to improper session validation which can result in access to unauthorized resources. IBM X-Force ID: 182019.

In Pivotal Spring-LDAP versions 1.3.0 - 2.3.1, when connected to some LDAP servers, when no additional attributes are bound, and when using LDAP BindAuthenticator with org.springframework.ldap.core.support.DefaultTlsDirContextAuthenticationStrategy as the authentication strategy, and setting userSearch, authentication is allowed with an arbitrary password when the username is correct. This occurs because some LDAP vendors require an explicit operation for the LDAP bind to take effect.

Improper Authentication vulnerability in TLS origin validation of Apache Traffic Server allows an attacker to create a man in the middle attack. This issue affects Apache Traffic Server 8.0.0 to 8.1.0.

Linux users running Lens 5.2.6 and earlier could be compromised by visiting a malicious website. The malicious website could make websocket connections from the victim's browser to Lens and so operate the local terminal feature. This would allow the attacker to execute arbitrary commands as the Lens user.

Improper authentication in firmware for Intel(R) AMT before versions 11.8.93, 11.22.93, 11.12.93, 12.0.92, 14.1.67, 15.0.42, 16.1.25 may allow an unauthenticated user to potentially enable escalation of privilege via network access.

An issue was discovered in Barrier before 2.4.0. The barriers component (aka the server-side implementation of Barrier) does not sufficiently verify the identify of connecting clients. Clients can thus exploit weaknesses in the provided protocol to cause denial-of-service or stage further attacks that could lead to information leaks or integrity corruption.

The implementations of EAP-PWD in wpa_supplicant EAP Peer, when built against a crypto library missing explicit validation on imported elements, do not validate the scalar and element values in EAP-pwd-Commit. An attacker may complete authentication, session key and control of the data connection with a client. Both hostapd with SAE support and wpa_supplicant with SAE support prior to and including version 2.4 are affected. Both hostapd with EAP-pwd support and wpa_supplicant with EAP-pwd support prior to and including version 2.7 are affected.

An issue was discovered in middleware.py in OpenStack Swauth through 1.2.0 when used with OpenStack Swift through 2.15.1. The Swift object store and proxy server are saving (unhashed) tokens retrieved from the Swauth middleware authentication mechanism to a log file as part of a GET URI. This allows attackers to bypass authentication by inserting a token into an X-Auth-Token header of a new request. NOTE: github.com/openstack/swauth URLs do not mean that Swauth is maintained by an official OpenStack project team.

IBM DB2 9.7, 10,1, 10.5, and 11.1 is vulnerable to an unauthorized command that allows the database to be activated when authentication type is CLIENT. IBM X-Force ID: 129830.

An issue was discovered in LemonLDAP::NG (aka lemonldap-ng) 2.0.13. When using the RESTServer plug-in to operate a REST password validation service (for another LemonLDAP::NG instance, for example) and using the Kerberos authentication method combined with another method with the Combination authentication plug-in, any password will be recognized as valid for an existing user.

Sympa before 6.2.59b.2 allows remote attackers to obtain full SOAP API access by sending any arbitrary string (except one from an expired cookie) as the cookie value to authenticateAndRun.

A flaw was found in SSSD version 1.9.0. The SSSD's access-provider logic causes the result of the HBAC rule processing to be ignored in the event that the access-provider is also handling the setup of the user's SELinux user context.

The Netlink implementation in the Linux kernel before 3.2.30 does not properly handle messages that lack SCM_CREDENTIALS data, which might allow local users to spoof Netlink communication via a crafted message, as demonstrated by a message to (1) Avahi or (2) NetworkManager.

An issue was discovered in the kernel in NetBSD 7.1. An Access Point (AP) forwards EAPOL frames to other clients even though the sender has not yet successfully authenticated to the AP. This might be abused in projected Wi-Fi networks to launch denial-of-service attacks against connected clients and makes it easier to exploit other vulnerabilities in connected clients.

The default configuration of the auth/saml plugin in Mahara before 1.4.2 sets the "Match username attribute to Remote username" option to false, which allows remote SAML IdP servers to spoof users of other SAML IdP servers by using the same internal username.

A key length flaw was found in Red Hat Ceph Storage. An attacker can exploit the fact that the key length is incorrectly passed in an encryption algorithm to create a non random key, which is weaker and can be exploited for loss of confidentiality and integrity on encrypted disks.

Improper authentication in some Intel(R) RealSense(TM) IDs may allow an unauthenticated user to potentially enable escalation of privilege via physical access.

VMware Workspace ONE Access has two authentication bypass vulnerabilities (CVE-2022-22955 & CVE-2022-22956) in the OAuth2 ACS framework. A malicious actor may bypass the authentication mechanism and execute any operation due to exposed endpoints in the authentication framework.

After the initial setup process, some steps of setup.php file are reachable not only by super-administrators, but by unauthenticated users as well. Malicious actor can pass step checks and potentially change the configuration of Zabbix Frontend.

Improper Authentication vulnerability in TLS origin verification of Apache Traffic Server allows for man in the middle attacks. This issue affects Apache Traffic Server 8.0.0 to 8.0.8.

Improper authentication in some Intel(R) NUC Kits NUC7PJYH and NUC7CJYH Realtek* SD Card Reader Driver installation software before version 10.0.19041.29098 may allow an authenticated user to potentially enable escalation of privilege via local access.

The FCGI (aka Fast CGI) module 0.70 through 0.73 for Perl, as used by CGI::Fast, uses environment variable values from one request during processing of a later request, which allows remote attackers to bypass authentication via crafted HTTP headers.

Authentication Bypass by Primary Weakness in GitHub repository adodb/adodb prior to 5.20.21.

Improper authentication in some Intel(R) Server Product OpenBMC firmware before version egs-1.09 may allow an authenticated user to enable escalation of privilege via local access.

Apache Shiro before 1.7.0, when using Apache Shiro with Spring, a specially crafted HTTP request may cause an authentication bypass.

The auth_send function in providers/ldap/ldap_auth.c in System Security Services Daemon (SSSD) 1.3.0, when LDAP authentication and anonymous bind are enabled, allows remote attackers to bypass the authentication requirements of pam_authenticate via an empty password.

In ectd before versions 3.4.10 and 3.3.23, gateway TLS authentication is only applied to endpoints detected in DNS SRV records. When starting a gateway, TLS authentication will only be attempted on endpoints identified in DNS SRV records for a given domain, which occurs in the discoverEndpoints function. No authentication is performed against endpoints provided in the --endpoints flag. This has been fixed in versions 3.4.10 and 3.3.23 with improved documentation and deprecation of the functionality.

Rocket Software UniData versions prior to 8.2.4 build 3003 and UniVerse versions prior to 11.3.5 build 1001 or 12.2.1 build 2002 suffer from an authentication bypass vulnerability, where a special username with a deterministic password can be leveraged to bypass authentication checks and execute OS commands as the root user.

An issue was discovered in Dropbear through 2020.81. Due to a non-RFC-compliant check of the available authentication methods in the client-side SSH code, it is possible for an SSH server to change the login process in its favor. This attack can bypass additional security measures such as FIDO2 tokens or SSH-Askpass. Thus, it allows an attacker to abuse a forwarded agent for logging on to another server unnoticed.

It was found that 389-ds-base since 1.3.6.1 up to and including 1.4.0.3 did not always handle internal hash comparison operations correctly during the authentication process. A remote, unauthenticated attacker could potentially use this flaw to bypass the authentication process under very rare and specific circumstances.

Improper authentication in some Intel(R) NUC Kit NUC11PH USB firmware installation software before version 1.1 for Windows may allow an authenticated user to potentially enable escalation of privilege via local access.

An authentication bypass vulnerability exists in libcurl <8.0.0 in the FTP connection reuse feature that can result in wrong credentials being used during subsequent transfers. Previously created connections are kept in a connection pool for reuse if they match the current setup. However, certain FTP settings such as CURLOPT_FTP_ACCOUNT, CURLOPT_FTP_ALTERNATIVE_TO_USER, CURLOPT_FTP_SSL_CCC, and CURLOPT_USE_SSL were not included in the configuration match checks, causing them to match too easily. This could lead to libcurl using the wrong credentials when performing a transfer, potentially allowing unauthorized access to sensitive information.

System Security Services Daemon (SSSD) before 1.0.1, when the krb5 auth_provider is configured but the KDC is unreachable, allows physically proximate attackers to authenticate, via an arbitrary password, to the screen-locking program on a workstation that has any user's Kerberos ticket-granting ticket (TGT); and might allow remote attackers to bypass intended access restrictions via vectors involving an arbitrary password in conjunction with a valid TGT.

An authentication bypass vulnerability exists libcurl <8.0.0 in the connection reuse feature which can reuse previously established connections with incorrect user permissions due to a failure to check for changes in the CURLOPT_GSSAPI_DELEGATION option. This vulnerability affects krb5/kerberos/negotiate/GSSAPI transfers and could potentially result in unauthorized access to sensitive information. The safest option is to not reuse connections if the CURLOPT_GSSAPI_DELEGATION option has been changed.