A flaw exists in Trading Technologies Messaging 7.1.28.3 (ttmd.exe) due to improper validation of user-supplied data when processing a type 8 message sent to default TCP RequestPort 10200. An unauthenticated, remote attacker can exploit this issue, via a specially crafted message, to terminate ttmd.exe.

free5GC is an open-source project for 5th generation (5G) mobile core networks. free5GC go-upf versions up to and including 1.2.6, corresponding to free5gc smf up to and including 1.4.0, have an Improper Input Validation and Protocol Compliance vulnerability leading to Denial of Service. Remote attackers can disrupt core network functionality by sending a malformed PFCP Association Setup Request. The UPF incorrectly accepts it, entering an inconsistent state that causes subsequent legitimate requests to trigger SMF reconnection loops and service degradation. All deployments of free5GC using the UPF and SMF components may be affected. As of time of publication, a fix is in development but not yet available. No direct workaround is available at the application level. Applying the official patch, once released, is recommended.

In nr modem, there is a possible system crash due to improper input validation. This could lead to remote denial of service with no additional execution privileges needed.

An improper input validation and protocol compliance vulnerability in free5GC v4.0.1 allows remote attackers to cause a denial of service. The UPF incorrectly accepts a malformed PFCP Association Setup Request, violating 3GPP TS 29.244. This places the UPF in an inconsistent state where a subsequent valid PFCP Session Establishment Request triggers a cascading failure, disrupting the SMF connection and causing service degradation.

Huawei Share function in P30 9.1.0.193(C00E190R2P1) smartphone has an insufficient input validation vulnerability. Attackers can exploit this vulnerability by sending crafted packets to the affected device. Successful exploit may cause the function will be disabled.

CWE-20: Improper Input Validation vulnerability exists that could cause a Denial Of Service when specific crafted FTP command is sent to the device.

Improper input validation in some Zoom Apps before version 6.2.0 may allow an unauthenticated user to conduct a denial of service via network access.

CVE-2024-45825 IMPACT A denial-of-service vulnerability exists in the affected products. The vulnerability occurs when a malformed CIP packet is sent over the network to the device and results in a major nonrecoverable fault causing a denial-of-service.

Input verification vulnerability in the system service module Impact: Successful exploitation of this vulnerability will affect availability.

In the Lustre file system before 2.12.3, the mdt module has an LBUG panic (via a large MDT Body eadatasize field) due to the lack of validation for specific fields of packets sent by a client.

The Synergy Systems & Solutions PLC & RTU system has a vulnerability in HUSKY RTU 6049-E70 firmware versions 5.0 and prior. Specially crafted malicious packets could cause disconnection of active authentic connections or reboot of device. This is a different issue than CVE-2019-16879 and CVE-2019-20046.

uap-core before 0.7.3 is vulnerable to a denial of service attack when processing crafted User-Agent strings. Some regexes are vulnerable to regular expression denial of service (REDoS) due to overlapping capture groups. This allows remote attackers to overload a server by setting the User-Agent header in an HTTP(S) request to maliciously crafted long strings. This has been patched in uap-core 0.7.3.

A vulnerability has been identified in SIPROTEC 4 and SIPROTEC Compact relays equipped with EN100 Ethernet communication modules (All versions). Specially crafted packets sent to port 50000/UDP of the EN100 Ethernet communication modules could cause a Denial-of-Service of the affected device. A manual reboot is required to recover the service of the device. At the time of advisory publication no public exploitation of this security vulnerability was known to Siemens.

The SIP module of some Huawei products have a denial of service (DoS) vulnerability. A remote attacker could exploit these three vulnerabilities by sending the specially crafted messages to the affected device. Due to the insufficient verification of the packets, successful exploit could allow the attacker to cause buffer overflow and dead loop, leading to DoS condition. Affected products can be found in https://www.huawei.com/en/psirt/security-advisories/huawei-sa-20200115-01-sip-en.

The SIP module of some Huawei products have a denial of service (DoS) vulnerability. A remote attacker could exploit these three vulnerabilities by sending the specially crafted messages to the affected device. Due to the insufficient verification of the packets, successful exploit could allow the attacker to cause buffer overflow and dead loop, leading to DoS condition. Affected products can be found in https://www.huawei.com/en/psirt/security-advisories/huawei-sa-20200115-01-sip-en.

illumos, as used in OmniOS Community Edition before r151030y, allows a kernel crash via an application with multiple threads calling sendmsg concurrently over a single socket, because uts/common/inet/ip/ip_attr.c mishandles conn_ixa dereferences.

A denial-of-service issue was discovered in the MQTT library in Arm Mbed OS 2017-11-02. The function readMQTTLenString() is called by the function MQTTDeserialize_publish() to get the length and content of the MQTT topic name. In the function readMQTTLenString(), mqttstring->lenstring.len is a part of user input, which can be manipulated. An attacker can simply change it to a larger value to invalidate the if statement so that the statements inside the if statement are skipped, letting the value of mqttstring->lenstring.data default to zero. Later, curn is accessed, which points to mqttstring->lenstring.data. On an Arm Cortex-M chip, the value at address 0x0 is actually the initialization value for the MSP register. It is highly dependent on the actual firmware. Therefore, the behavior of the program is unpredictable from this time on.

A vulnerability in the ISDN functions of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause the device to reload. The vulnerability is due to incorrect processing of specific values in the Q.931 information elements. An attacker could exploit this vulnerability by calling the affected device with specific Q.931 information elements being present. An exploit could allow the attacker to cause the device to reload, resulting in a denial of service (DoS) condition on an affected device.

A vulnerability in the web proxy functionality of Cisco AsyncOS Software for Cisco Web Security Appliance could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper validation of HTTP and HTTPS requests. An attacker could exploit this vulnerability by sending a malformed HTTP or HTTPS request to an affected device. An exploit could allow the attacker to cause a restart of the web proxy process, resulting in a temporary DoS condition.

A vulnerability in the Network-Based Application Recognition (NBAR) feature of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload. This vulnerability is due to a parsing issue on DNS packets. An attacker could exploit this vulnerability by sending crafted DNS packets through routers that are running an affected version and have NBAR enabled. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition.

A vulnerability has been identified in SIMATIC CN 4100 (All versions < V2.7). The affected application allows IP configuration change without authentication to the device. This could allow an attacker to cause denial of service condition.

An issue in Cesanta mjs 2.20.0 allows a remote attacker to cause a denial of service via the mjs_op_json_parse function in the msj.c file.

In goform/setSysTools on Tenda N301 wireless routers, attackers can trigger a device crash via a zero wanMTU value. (Prohibition of this zero value is only enforced within the GUI.)

An issue in ollama v.0.12.10 allows a remote attacker to cause a denial of service via the fs/ggml/gguf.go, function readGGUFV1String reads a string length from untrusted GGUF metadata

An issue was discovered in HCC Nichestack 3.0. The code that parses TCP packets relies on an unchecked value of the IP payload size (extracted from the IP header) to compute the length of the TCP payload within the TCP checksum computation function. When the IP payload size is set to be smaller than the size of the IP header, the TCP checksum computation function may read out of bounds (a low-impact write-out-of-bounds is also possible).

A vulnerability in the TCP proxy functionality for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the device to restart unexpectedly, resulting in a denial of service (DoS) condition. The vulnerability is due to an error in TCP-based packet inspection, which could cause the TCP packet to have an invalid Layer 2 (L2)-formatted header. An attacker could exploit this vulnerability by sending a crafted TCP packet sequence to the targeted device. A successful exploit could allow the attacker to cause a DoS condition.

TestingPlatform is a testing platform for Internet Security Standards. Prior to version 2.1.1, user input is not filtered correctly. Nmap options are accepted. In this particular case, the option to create log files is accepted in addition to a host name (and even without). A log file is created at the location specified. These files are created as root. If the file exists, the existing file is being rendered useless. This can result in denial of service. Additionally, input for scanning can be any CIDR blocks passed to nmap. An attacker can scan 0.0.0.0/0 or even local networks. Version 2.1.1 contains a patch for this issue.

An issue was discovered on ASUS HG100, MW100, WS-101, TS-101, AS-101, MS-101, DL-101 devices using ZigBee PRO. Attackers can use the ZigBee trust center rejoin procedure to perform mutiple denial of service attacks.

An issue was discovered on ASUS HG100, MW100, WS-101, TS-101, AS-101, MS-101, DL-101 devices using ZigBee PRO. Attackers can utilize the "discover ZigBee network procedure" to perform a denial of service attack.

Multiple vulnerabilities in the REST API of Cisco UCS Director and Cisco UCS Director Express for Big Data may allow a remote attacker to bypass authentication or conduct directory traversal attacks on an affected device. For more information about these vulnerabilities, see the Details section of this advisory.

An issue was discovered on Xiaomi DGNWG03LM, ZNCZ03LM, MCCGQ01LM, RTCGQ01LM devices. Attackers can utilize the "discover ZigBee network procedure" to perform a denial of service attack.

The com.eypcnnapps.quickreboot (aka Eyuep Can Yilmaz {ROOT] Quick Reboot) application 1.0.8 for Android has exposed broadcast receivers for PowerOff, Reboot, and Recovery (e.g., com.eypcnnapps.quickreboot.widget.PowerOff) that are susceptible to unauthorized broadcasts because of missing input validation.

An issue discovered in GPAC 2.3-DEV-rev605-gfc9e29089-master in MP4Box in gf_avc_change_vui /afltest/gpac/src/media_tools/av_parsers.c:6872:55 allows attackers to crash the application.

An issue was discovered on Xiaomi DGNWG03LM, ZNCZ03LM, MCCGQ01LM, WSDCGQ01LM, RTCGQ01LM devices. Attackers can use the ZigBee trust center rejoin procedure to perform mutiple denial of service attacks.

IBM Db2 for Linux, UNIX and Windows (includes Db2 Connect Server) 10.5, 11.1, and 11.5 is vulnerable to denial of service with a specially crafted query. IBM X-Force ID: 266166.

IBM Db2 for Linux, UNIX and Windows (includes Db2 Connect Server) 11.5 federated server is vulnerable to a denial of service when a specially crafted cursor is used. IBM X-Force ID: 269367.

A vulnerability has been identified in Opcenter Execution Foundation (All versions < V2407), Opcenter Quality (All versions < V2312), SIMATIC PCS neo (All versions < V4.1), SINEC NMS (All versions < V2.0 SP1), Totally Integrated Automation Portal (TIA Portal) V14 (All versions), Totally Integrated Automation Portal (TIA Portal) V15.1 (All versions), Totally Integrated Automation Portal (TIA Portal) V16 (All versions), Totally Integrated Automation Portal (TIA Portal) V17 (All versions < V17 Update 8), Totally Integrated Automation Portal (TIA Portal) V18 (All versions < V18 Update 3). The affected application contains an improper input validation vulnerability that could allow an attacker to bring the service into a Denial-of-Service state by sending a specifically crafted message to 4004/tcp. The corresponding service is auto-restarted after the crash is detected by a watchdog.

All versions of package lite-server are vulnerable to Denial of Service (DoS) when an attacker sends an HTTP request and includes control characters that the decodeURI() function is unable to parse.

main/translate.c in Sangoma Asterisk 13.28.0 and 16.5.0 allows a remote attacker to send a specific RTP packet during a call and cause a crash in a specific scenario.

IBM Db2 for Linux, UNIX and Windows (includes Db2 Connect Server) 11.5 federated server is vulnerable to a denial of service when a specially crafted cursor is used. IBM X-Force ID: 268759.

An issue was discovered in Foxit PhantomPDF before 8.3.11. The application could crash due to the lack of proper validation of the existence of an object prior to performing operations on that object when executing JavaScript.

An Improper Input Validation vulnerability in the Packet Forwarding Engine of Juniper Networks Junos OS allows an unauthenticated, network-based attacker to cause memory leak, leading to Denial of Service (DoS). On all Junos OS QFX5000 Series platforms, when pseudo-VTEP (Virtual Tunnel End Point) is configured under EVPN-VXLAN scenario, and specific DHCP packets are transmitted, DMA memory leak is observed. Continuous receipt of these specific DHCP packets will cause memory leak to reach 99% and then cause the protocols to stop working and traffic is impacted, leading to Denial of Service (DoS) condition. A manual reboot of the system recovers from the memory leak. To confirm the memory leak, monitor for "sheaf:possible leak" and "vtep not found" messages in the logs. This issue affects: Juniper Networks Junos OS QFX5000 Series: * All versions prior to 20.4R3-S6; * 21.1 versions prior to 21.1R3-S5; * 21.2 versions prior to 21.2R3-S5; * 21.3 versions prior to 21.3R3-S4; * 21.4 versions prior to 21.4R3-S3; * 22.1 versions prior to 22.1R3-S2; * 22.2 versions prior to 22.2R2-S2, 22.2R3; * 22.3 versions prior to 22.3R2-S1, 22.3R3; * 22.4 versions prior to 22.4R1-S2, 22.4R2.