BT:Classic: Multiple missing buf length checks

Unsafe handling in bt_conn_tx_processor causes a use-after-free, resulting in a write-before-zero. The written 4 bytes are attacker-controlled, enabling precise memory corruption.

A malicious BLE device can send a specific order of packet sequence to cause a DoS attack on the victim BLE device

A vulnerability was identified in the handling of Bluetooth Low Energy (BLE) fixed channels (such as SMP or ATT). Specifically, an attacker could exploit a flaw that causes the BLE target (i.e., the device under attack) to attempt to disconnect a fixed channel, which is not allowed per the Bluetooth specification. This leads to undefined behavior, including potential assertion failures, crashes, or memory corruption, depending on the BLE stack implementation.

A bitwise shift vulnerability in Zephyr's PTP subsystem allows a remote attacker to cause undefined behavior and potential system crashes. An attacker sends a crafted PTP_MSG_MANAGEMENT message to set an unvalidated negative log_announce_interval value in the port's data set. When a subsequent PTP_MSG_ANNOUNCE message is processed, port_timer_set_timeout_random computes a timeout as NSEC_PER_SEC >> -log_seconds; if the attacker-supplied value is sufficiently negative (e.g., -127), the shift amount exceeds the 64-bit integer width, triggering undefined behavior in C. This can cause a system crash via a compiler-generated illegal instruction trap on some architectures, or produce an erroneous zero timeout leading to resource starvation loops or other logical errors.

The Zephyr PL011 UART driver (drivers/serial/uart_pl011.c) contains an unbounded software loop in pl011_irq_tx_enable() that repeatedly invokes the interrupt-driven application callback while the TX interrupt mask bit (PL011_IMSC_TXIM) is set, to work around the controller's level-transition TX-interrupt behavior. When CTS hardware flow control is enabled (devicetree hw-flow-control or runtime UART_CFG_FLOW_CTRL_RTS_CTS) and the wired serial peer de-asserts CTS, the controller stops draining the TX FIFO; pl011_fifo_fill() then returns 0 on every call while the application still has pending data and therefore never disables the TX interrupt. The loop condition never clears, so the thread that called uart_irq_tx_enable() (e.g. h4_send() in the Bluetooth HCI H4 driver) spins indefinitely, hanging the executing context and stalling the transport — a denial of service (CWE-835). An attacker controlling the device attached to the UART's CTS line can trigger the hang by withholding CTS during transmission. Impact is availability only; there is no memory-safety, confidentiality, or integrity consequence. The vulnerable loop was introduced in commit b783bc8448ef (Feb 2025) and shipped in releases v4.1.0 through v4.4.0. The fix breaks out of the loop when CTS is blocking and arms the CTS modem-status interrupt to resume transmission when CTS re-asserts.

No proper validation of the length of user input in olcp_ind_handler in zephyr/subsys/bluetooth/services/ots/ots_client.c.

Zephyr Bluetooth unchecked packet data results in denial of service. Zephyr versions >= v1.14.2, >= v2.2.0 contain Improper Handling of Parameters (CWE-233). For more information, see https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-f6vh-7v4x-8fjp

In the Zephyr project Bluetooth subsystem, certain duplicate and back-to-back packets can cause incorrect behavior, resulting in a denial of service. This issue affects: zephyrproject-rtos zephyr version 2.2.0 and later versions, and version 1.14.0 and later versions.

BT: Classic: SDP OOB access in get_att_search_list

BT: HCI: adv_ext_report Improper discarding in adv_ext_report

A remote, unauthenticated BLE peer can trigger a 2-byte out-of-bounds write in the Bluetooth host during L2CAP LE CoC SDU reassembly. When the application enables segmentation (via chan_ops.alloc_buf) and the chosen RX pool has a user_data_size smaller than 2 bytes, the segmentation counter stored in the net_buf user_data area is written out of bounds in l2cap_chan_le_recv_seg (subsys/bluetooth/host/l2cap.c). The observed effects are an AddressSanitizer abort and, without ASan, heap corruption / fatal error.

Assertion reachable with repeated LL_CONNECTION_PARAM_REQ. Zephyr versions >= v1.14 contain Reachable Assertion (CWE-617). For more information, see https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-46h3-hjcq-2jjr

Unexpected Pointer Aliasing in IEEE 802154 Fragment Reassembly in Zephyr. Zephyr versions >= >=2.4.0 contain NULL Pointer Dereference (CWE-476). For more information, see https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-p86r-gc4r-4mq3

Lack of proper validation in HCI Host stack initialization can cause a crash of the bluetooth stack

Potential buffer overflow vulnerability in the Zephyr CAN bus subsystem

A malicious / defect bluetooth controller can cause a Denial of Service due to unchecked input in le_read_buffer_size_complete.

Potential buffer overflow vulnerability in the Zephyr IEEE 802.15.4 nRF 15.4 driver

Unchecked user input length in /subsys/net/l2/wifi/wifi_shell.c can cause buffer overflows.

‭An out-of-bound write can lead to an arbitrary code execution. Even on devices with some form of memory protection, this can still lead to‬ ‭a crash and a resultant denial of service.‬

There is a potential OOB Write vulnerability in the gen_prov_start function in pb_adv.c. The full length of the received data is copied into the link.rx.buf receiver buffer without any validation on the data size.

Improper handling of malformed Connection Request with the interval set to be 1 (which supposed to be illegal) and the chM 0x7CFFFFFFFF triggers a crash. The peripheral will not be connectable after it.

An integer overflow condition exists in Bluetooth Host stack, within the bt_br_acl_recv routine a critical path for processing inbound BR/EDR L2CAP traffic.

Parameters are not validated or sanitized, and are later used in various internal operations.

In utf8_trunc in zephyr/lib/utils/utf8.c, last_byte_p can point to one byte before the string pointer if the string is empty.

In ascs_cp_rsp_add in /subsys/bluetooth/audio/ascs.c, an unchecked tailroom could lead to a global buffer overflow.

BT: Unchecked user input in bap_broadcast_assistant

BT: Missing length checks of net_buf in rfcomm_handle_data

No proper validation of the length of user input in olcp_ind_handler in zephyr/subsys/bluetooth/services/ots/ots_client.c.

An malicious BLE device can crash BLE victim device by sending malformed gatt packet

Invalid interval in CONNECT_IND leads to Division by Zero. Zephyr versions >= v1.14.0 Divide By Zero (CWE-369). For more information, see https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-7364-p4wc-8mj4