Cisco 6400 Access Concentrator Node Route Processor 2 (NRP2) 12.1DC card does not properly disable access when a password has not been set for vtys, which allows remote attackers to obtain access via telnet.

Cisco Aironet 340 Series wireless bridge before 8.55 does not properly disable access to the web interface, which allows remote attackers to modify its configuration.

Cisco 12000 with IOS 12.0 and lines card based on Engine 2 does not properly handle an outbound ACL when an input ACL is not configured on all the interfaces of a multi port line card, which could allow remote attackers to bypass the intended access controls.

Multiple vulnerabilities in Cisco Small Business RV160, RV260, RV340, and RV345 Series Routers could allow an attacker to do any of the following: Execute arbitrary code Elevate privileges Execute arbitrary commands Bypass authentication and authorization protections Fetch and run unsigned software Cause denial of service (DoS) For more information about these vulnerabilities, see the Details section of this advisory.

Cisco 12000 with IOS 12.0 and line cards based on Engine 2 does not block non-initial packet fragments, which allows remote attackers to bypass the ACL.

Multiple vulnerabilities in Cisco Small Business RV160, RV260, RV340, and RV345 Series Routers could allow an attacker to do any of the following: Execute arbitrary code Elevate privileges Execute arbitrary commands Bypass authentication and authorization protections Fetch and run unsigned software Cause denial of service (DoS) For more information about these vulnerabilities, see the Details section of this advisory.

The Cisco Web Management interface in routers running CBOS 2.4.1 and earlier does not log invalid logins, which allows remote attackers to guess passwords without detection.

Cisco Catalyst 2900 Virtual LAN (VLAN) switches allow remote attackers to inject 802.1q frames into another VLAN by forging the VLAN identifier in the trunking tag.

Vulnerability in Cisco IOS 11.1CC and 11.1CT with distributed fast switching (DFS) enabled allows remote attackers to bypass certain access control lists when the router switches traffic from a DFS-enabled interface to an interface that does not have DFS enabled, as described by Cisco bug CSCdk35564.

Vulnerability in Cisco routers versions 8.2 through 9.1 allows remote attackers to bypass access control lists when extended IP access lists are used on certain interfaces, the IP route cache is enabled, and the access list uses the "established" keyword.

Web Cache Control Protocol (WCCP) in Cisco Cache Engine for Cisco IOS 11.2 and earlier does not use authentication, which allows remote attackers to redirect HTTP traffic to arbitrary hosts via WCCP packets to UDP port 2048.

SQL injection vulnerability in the Enterprise Mobility Application (EMApp) interface in Cisco Unified Communications Manager (UCM) allows remote attackers to execute arbitrary SQL commands via a crafted URL, aka Bug ID CSCum05302.

Check Point Firewall-1 allows remote attackers to bypass port access restrictions on an FTP server by forcing it to send malicious packets that Firewall-1 misinterprets as a valid 227 response to a client's PASV attempt.

Cisco PIX Private Link 4.1.6 and earlier does not properly process certain commands in the configuration file, which reduces the effective key length of the DES key to 48 bits instead of 56 bits, which makes it easier for an attacker to find the proper key via a brute force attack.

A default configuration of CiscoSecure Access Control Server (ACS) allows remote users to modify the server database without authentication.

AAA authentication on Cisco systems allows attackers to execute commands without authorization.

Some classic Cisco IOS devices have a vulnerability in the PPP CHAP authentication to establish unauthorized PPP connections.

Cisco IOS 12.2T through 12.4 allows remote attackers to bypass Authentication, Authorization, and Accounting (AAA) RADIUS authentication, if the fallback method is set to none, via a long username.

SQL injection vulnerability in the IP Manager Assistant (IPMA) interface in Cisco Unified Communications Manager (UCM) 10.0(1) and earlier allows remote attackers to execute arbitrary SQL commands via a crafted URL, aka Bug ID CSCum05326.

SQL injection vulnerability in the Certificate Authority Proxy Function (CAPF) implementation in Cisco Unified Communications Manager (Unified CM) 10.0(1) and earlier allows remote attackers to execute arbitrary SQL commands via a crafted URL, aka Bug ID CSCum46483.

SQL injection vulnerability in the CallManager Interactive Voice Response (CMIVR) interface in Cisco Unified Communications Manager (UCM) allows remote attackers to execute arbitrary SQL commands via a crafted URL, aka Bug ID CSCum05318.

SQL injection vulnerability in the Java database interface in Cisco Unified Communications Manager (UCM) 10.0(1) and earlier allows remote attackers to execute arbitrary SQL commands via a crafted URL, aka Bug ID CSCum05313.

Cisco IOS 12.2T, 12.3 and 12.3T, when processing an ISAKMP profile that specifies XAUTH authentication after Phase 1 negotiation, may not process certain attributes in the ISAKMP profile that specifies XAUTH, which allows remote attackers to bypass XAUTH and move to Phase 2 negotiations.

Multiple vulnerabilities in Cisco SD-WAN vManage Software could allow an unauthenticated, remote attacker to execute arbitrary code or gain access to sensitive information, or allow an authenticated, local attacker to gain escalated privileges or gain unauthorized access to the application. For more information about these vulnerabilities, see the Details section of this advisory.

Multiple vulnerabilities exist in the web-based management interface of Cisco Small Business RV Series Routers. A remote attacker could execute arbitrary commands or bypass authentication and upload files on an affected device. For more information about these vulnerabilities, see the Details section of this advisory.

Multiple vulnerabilities in the web-based management interface of Cisco HyperFlex HX could allow an unauthenticated, remote attacker to perform command injection attacks against an affected device. For more information about these vulnerabilities, see the Details section of this advisory.

Buffer overflow in Firewall Authentication Proxy for FTP and/or Telnet Sessions for Cisco IOS 12.2ZH and 12.2ZL, 12.3 and 12.3T, and 12.4 and 12.4T allows remote attackers to cause a denial of service and possibly execute arbitrary code via crafted user authentication credentials.

Cisco VPN 3000 Concentrator 2.2.x, and 3.x before 3.5.1, allows restricted administrators to obtain user passwords that are stored in plaintext in HTML source code.

Cross-site scripting vulnerability in CiscoSecure ACS 3.0 allows remote attackers to execute arbitrary script or HTML as other web users via the action argument in a link to setup.exe.

Multiple vulnerabilities in Cisco SD-WAN products could allow an unauthenticated, remote attacker to execute attacks against an affected device. For more information about these vulnerabilities, see the Details section of this advisory.

Multiple vulnerabilities in Cisco SD-WAN products could allow an unauthenticated, remote attacker to execute attacks against an affected device. For more information about these vulnerabilities, see the Details section of this advisory.

Cisco IOS Firewall Feature set, aka Context Based Access Control (CBAC) or Cisco Secure Integrated Software, for IOS 11.2P through 12.2T does not properly check the IP protocol type, which could allow remote attackers to bypass access control lists.

Cisco switches and routers running CBOS 2.3.8 and earlier use predictable TCP Initial Sequence Numbers (ISN), which allows remote attackers to spoof or hijack TCP connections.

The mailguard feature in Cisco Secure PIX Firewall 5.2(2) and earlier does not properly restrict access to SMTP commands, which allows remote attackers to execute restricted commands by sending a DATA command before sending the restricted commands.

By design, the "established" command on the Cisco PIX firewall allows connections from one host to arbitrary ports of a target host if an alternative conduit has already been allowed, which can cause administrators to configure less restrictive access controls than intended if they do not understand this functionality.

The default configuration of IOS HTTP server in Cisco Router Web Setup (CRWS) before 3.3.0 build 31 does not require credentials, which allows remote attackers to access the server with arbitrary privilege levels, aka bug CSCsa78190.

Cisco routers 9.17 and earlier allow remote attackers to bypass security restrictions via certain IP source routed packets that should normally be denied using the "no ip source-route" command.

A vulnerability in the Session Description Protocol (SDP) parser of Cisco Meeting Server could allow an unauthenticated, remote attacker to execute arbitrary code on an affected system. This vulnerability affects the following products: Cisco Meeting Server releases prior to Release 2.0.3, Acano Server releases 1.9.x prior to Release 1.9.5, Acano Server releases 1.8.x prior to Release 1.8.17. More Information: CSCva76004. Known Affected Releases: 1.8.x 1.92.0.

The HTTP server in Cisco 7xx series routers 3.2 through 4.2 is enabled by default, which allows remote attackers to change the router's configuration.

Cisco Cloud Services Platform (CSP) 2100 2.0 allows remote attackers to execute arbitrary code via a crafted dnslookup command in an HTTP request, aka Bug ID CSCuz89093.

Cisco Secure ACS does not require authentication when Cisco Trust Agent (CTA) transmits posture information, which might allow remote attackers to gain network access via a spoofed Network Endpoint Assessment posture, aka "NACATTACK." NOTE: this attack might be limited to authenticated users and devices.

Multiple vulnerabilities in the web-based management interface of the Cisco Catalyst Passive Optical Network (PON) Series Switches Optical Network Terminal (ONT) could allow an unauthenticated, remote attacker to perform the following actions: Log in with a default credential if the Telnet protocol is enabled Perform command injection Modify the configuration For more information about these vulnerabilities, see the Details section of this advisory.

Buffer overflow in decode.cpp in Cisco OpenH264 1.2.0 and earlier allows remote attackers to execute arbitrary code via an encoded media file.

Cisco Clean Access (CCA) 3.3.0 to 3.3.9, 3.4.0 to 3.4.5, and 3.5.0 to 3.5.3 does not properly authenticate users when invoking API methods, which could allow remote attackers to bypass security checks, change the assigned role of a user, or disconnect users.

Cisco devices running Application and Content Networking System (ACNS) 4.x, 5.0, 5.1, or 5.2 use a default password when the setup dialog has not been run, which allows remote attackers to gain access.

Cisco Secure Access Control Server (ACS) 3.2(3) and earlier spawns a separate unauthenticated TCP connection on a random port when a user authenticates to the ACS GUI, which allows remote attackers to bypass authentication by connecting to that port from the same IP address.

Cisco Unified Computing System (UCS) Central Software 1.3(1b) and earlier allows remote attackers to execute arbitrary OS commands via a crafted HTTP request, aka Bug ID CSCuv33856.

Multiple vulnerabilities in the web-based management interface of the Cisco Catalyst Passive Optical Network (PON) Series Switches Optical Network Terminal (ONT) could allow an unauthenticated, remote attacker to perform the following actions: Log in with a default credential if the Telnet protocol is enabled Perform command injection Modify the configuration For more information about these vulnerabilities, see the Details section of this advisory.