A vulnerability in the Open Shortest Path First (OSPF) implementation in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak on an affected device. The vulnerability is due to incorrect processing of certain OSPF packets. An attacker could exploit this vulnerability by sending a series of crafted OSPF packets to be processed by an affected device. A successful exploit could allow the attacker to continuously consume memory on an affected device and eventually cause it to reload, resulting in a denial of service (DoS) condition.

CryptoLib provides a software-only solution using the CCSDS Space Data Link Security Protocol - Extended Procedures (SDLS-EP) to secure communications between a spacecraft running the core Flight System (cFS) and a ground station. A memory leak vulnerability was identified in the `crypto_handle_incrementing_nontransmitted_counter` function of CryptoLib versions 1.3.3 and prior. This vulnerability can lead to resource exhaustion and degraded system performance over time, particularly in long-running processes or systems processing large volumes of data. The vulnerability is present in the `crypto_handle_incrementing_nontransmitted_counter` function within `crypto_tc.c`. The function allocates memory using `malloc` without ensuring the allocated memory is always freed. This issue can lead to resource exhaustion, reduced system performance, and potentially a Denial of Service (DoS) in environments where CryptoLib is used in long-running processes or with large volumes of data. Any system using CryptoLib, especially those handling high-throughput or continuous data streams, could be impacted. As of time of publication, no known patched versions are available.

An issue was discovered in the sized-chunks crate through 0.6.2 for Rust. In the Chunk implementation, insert_from can have a memory-safety issue upon a panic.

pdf2xml v2.0 was discovered to contain a memory leak in the function TextPage::testLinkedText.

A buffer overflow in Mikrotik RouterOS 6.47 allows unauthenticated attackers to cause a denial of service (DOS) via crafted SMB requests.

Denial of Service issue in FFmpeg 4.2 due to resource management errors via fftools/cmdutils.c.

JerryScript Git version 14ff5bf does not sufficiently track and release allocated memory via jerry-core/ecma/operations/ecma-regexp-object.c after RegExp, which causes a memory leak.

Multiple Cisco products are affected by a vulnerability in the way the Snort detection engine processes ICMP traffic that could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper memory resource management while the Snort detection engine is processing ICMP packets. An attacker could exploit this vulnerability by sending a series of ICMP packets through an affected device. A successful exploit could allow the attacker to exhaust resources on the affected device, causing the device to reload.

Specific IPv6 packets sent by clients processed by the Routing Engine (RE) are improperly handled. These IPv6 packets are designed to be blocked by the RE from egressing the RE. Instead, the RE allows these specific IPv6 packets to egress the RE, at which point a mbuf memory leak occurs within the Juniper Networks Junos OS device. This memory leak eventually leads to a kernel crash (vmcore), or the device hanging and requiring a power cycle to restore service, creating a Denial of Service (DoS) condition. During the time where mbufs are rising, yet not fully filled, some traffic from client devices may begin to be black holed. To be black holed, this traffic must match the condition where this traffic must be processed by the RE. Continued receipt and attempted egress of these specific IPv6 packets from the Routing Engine (RE) will create an extended Denial of Service (DoS) condition. Scenarios which have been observed are: 1. In a single chassis, single RE scenario, the device will hang without vmcore, or a vmcore may occur and then hang. In this scenario the device needs to be power cycled. 2. In a single chassis, dual RE scenario, the device master RE will fail over to the backup RE. In this scenario, the master and the backup REs need to be reset from time to time when they vmcore. There is no need to power cycle the device. 3. In a dual chassis, single RE scenario, the device will hang without vmcore, or a vmcore may occur and then hang. In this scenario, the two chassis' design relies upon some type of network level redundancy - VRRP, GRES, NSR, etc. - 3.a In a commanded switchover, where nonstop active routing (NSR) is enabled no session loss is observed. 4. In a dual chassis, dual chassis scenario, rely upon the RE to RE failover as stated in the second scenario. In the unlikely event that the device does not switch RE to RE gracefully, then the fallback position is to the network level services scenario in the third scenario. This issue affects: Juniper Networks Junos OS 16.1 versions prior to 16.1R7-S6; 16.1 version 16.1X70-D10 and later; 16.2 versions prior to 16.2R2-S11; 17.1 versions prior to 17.1R2-S11, 17.1R3-S1; 17.2 versions prior to 17.2R1-S9, 17.2R2-S8, 17.2R3-S3; 17.3 versions prior to 17.3R3-S6; 17.4 versions prior to 17.4R2-S9, 17.4R3; 18.1 versions prior to 18.1R3-S7; 18.2 versions prior to 18.2R3-S2; 18.2X75 versions prior to 18.2X75-D50, 18.2X75-D410; 18.3 versions prior to 18.3R1-S6, 18.3R2-S2, 18.3R3; 18.4 versions prior to 18.4R1-S6, 18.4R2-S2, 18.4R3; 19.1 versions prior to 19.1R1-S3, 19.1R2; 19.2 versions prior to 19.2R1-S2, 19.2R2. This issue does not affect releases prior to Junos OS 16.1R1.

An h2c direct connection to Apache Tomcat 10.0.0-M1 to 10.0.0-M6, 9.0.0.M5 to 9.0.36 and 8.5.1 to 8.5.56 did not release the HTTP/1.1 processor after the upgrade to HTTP/2. If a sufficient number of such requests were made, an OutOfMemoryException could occur leading to a denial of service.

A Missing Release of Memory after Effective Lifetime vulnerability in the Application Quality of Experience (appqoe) subsystem of the PFE of Juniper Networks Junos OS on SRX Series allows an unauthenticated network based attacker to cause a Denial of Service (DoS). Upon receiving specific traffic a memory leak will occur. Sustained processing of such specific traffic will eventually lead to an out of memory condition that prevents all services from continuing to function, and requires a manual restart to recover. A device is only vulnerable when advance(d) policy based routing (APBR) is configured and AppQoE (sla rule) is not configured for these APBR rules. This issue affects Juniper Networks Junos OS on SRX Series: 20.3 versions prior to 20.3R3-S2; 20.4 versions prior to 20.4R3-S2; 21.1 versions prior to 21.1R3; 21.2 versions prior to 21.2R2-S1, 21.2R3; 21.3 versions prior to 21.3R1-S2, 21.3R2. This issue does not affect Juniper Networks Junos OS versions prior to 20.3R1.

There is a Memory leak vulnerability with the codec detection module in Huawei Smartphone.Successful exploitation of this vulnerability may cause the device to restart due to memory exhaustion.

A flaw was found in JBoss-client. The vulnerability occurs due to a memory leak on the JBoss client-side, when using UserTransaction repeatedly and leads to information leakage vulnerability.

K7TSMngr.exe in K7Computing K7AntiVirus Premium 15.1.0.53 has a Memory Leak.

A Missing Release of Memory after Effective Lifetime vulnerability in the routing protocol daemon of Juniper Networks Junos OS and Junos OS Evolved allows an unauthenticated, network based attacker to cause a Denial of Service (DoS). In a BGP rib sharding scenario, when an attribute of an active BGP route is updated memory will leak. As rpd memory usage increases over time the rpd process will eventually run out of memory, crash, and restart. The memory utilization can be monitored with the following CLI commands: show task memory show system processes extensive | match rpd This issue affects: Juniper Networks Junos OS 20.3 versions prior to 20.3R3-S2; 20.4 versions prior to 20.4R3-S6; 21.1 versions prior to 21.1R3; 21.2 versions prior to 21.2R3; 21.3 versions prior to 21.3R2. Juniper Networks Junos OS Evolved 20.3-EVO version 20.3R1-EVO and later versions; 20.4-EVO versions prior to 20.4R3-S6-EVO; 21.2-EVO versions prior to 21.2R3-EVO; 21.3-EVO versions prior to 21.3R2-EVO.