Philips Hue Bridge HomeKit Accessory Protocol Transient Pairing Mode Authentication Bypass Vulnerability. This vulnerability allows network-adjacent attackers to bypass authentication on affected installations of Philips Hue Bridge. Authentication is not required to exploit this vulnerability. The specific flaw exists within the configuration of the HomeKit Accessory Protocol service, which listens on TCP port 8080 by default. The issue results from the lack of authentication prior to allowing access to functionality. An attacker can leverage this vulnerability to bypass authentication on the system. Was ZDI-CAN-28374.

In Philips Alice 6 System version R8.0.2 or prior, the lack of proper data encryption passes up the guarantees of confidentiality, integrity, and accountability that properly implemented encryption conveys.

The software does not perform any authentication for critical system functionality.

Philips iSite and IntelliSpace PACS, iSite PACS, all versions, and IntelliSpace PACS, all versions. Default credentials and no authentication within third party software may allow an attacker to compromise a component of the system.

Zyxel CloudCNM SecuManager 3.1.0 and 3.1.1 has no authentication for /registerCpe requests.

Zyxel CloudCNM SecuManager 3.1.0 and 3.1.1 has no authentication for /cnr requests.

ONLYOFFICE all versions as of 2021-11-08 is affected by Incorrect Access Control. An authentication bypass in the document editor allows attackers to edit documents without authentication.

TOTOLINK X6000R V9.4.0cu.852_B20230719 is vulnerable to Incorrect Access Control.Attackers can reset login password & WIFI passwords without authentication.

An access control issue in Canaan Avalon ASIC Miner 2020.3.30 and below allows unauthenticated attackers to arbitrarily change user passwords via a crafted POST request.

Zoho ManageEngine ServiceDesk Plus before 11.1 build 11115 allows remote unauthenticated attackers to change the installation status of deployed agents.

Barco Control Room Management Suite web application, which is part of TransForm N before 3.14, is exposing a license file upload mechanism. This upload can be executed without authentication.

GitLab 7.10 through 12.8.1 has Incorrect Access Control. Under certain conditions where users should have been required to configure two-factor authentication, it was not being required.

A vulnerability has been identified in SICAM MMU (All versions < V2.05), SICAM SGU (All versions), SICAM T (All versions < V2.18). An attacker with access to the network could be able to install specially crafted firmware to the device.

The /device/acceptBind end-point for Ourphoto App version 1.4.1 does not require authentication or authorization. The user_token header is not implemented or present on this end-point. An attacker can send a request to bind their account to any users picture frame, then send a POST request to accept their own bind request, without the end-users approval or interaction.

The createComment mutation in the WPGraphQL 0.2.3 plugin for WordPress allows unauthenticated users to post comments on any article, even when 'allow comment' is disabled.

The devices allow access to an unprotected endpoint that allows MPFS file system binary image upload without authentication. The MPFS2 file system module provides a light-weight read-only file system that can be stored in external EEPROM, external serial flash, or internal flash program memory. This file system serves as the basis for the HTTP2 web server module, but is also used by the SNMP module and is available to other applications that require basic read-only storage capabilities. This can be exploited to overwrite the flash program memory that holds the web server's main interfaces and execute arbitrary code.

Online Store System v1.0 delete_product.php doesn't check to see if a user authtenticated or has administrative rights allowing arbitrary product deletion.

An issue was discovered in /bin/goahead on D-Link DIR-823G devices with firmware 1.02B03. There is incorrect access control allowing remote attackers to hijack the DNS service configuration of all clients in the WLAN, without authentication, via the SetWanSettings HNAP API.

Apache Hive before 3.1.3 "CREATE" and "DROP" function operations does not check for necessary authorization of involved entities in the query. It was found that an unauthorized user can manipulate an existing UDF without having the privileges to do so. This allowed unauthorized or underprivileged users to drop and recreate UDFs pointing them to new jars that could be potentially malicious.

In JetBrains YouTrack before 2025.1.76253 deletion of issues was possible due to missing permission checks in API

On SOYAL AR-727H and AR-829Ev5 devices, all CGI programs allow unauthenticated POST access.

Fresenius Kabi Agilia SP MC WiFi vD25 and prior has a default configuration page accessible without authentication. An attacker may use this functionality to change the exposed configuration values such as network settings.

The Alcatel Lucent I-240W-Q GPON ONT using firmware version 3FE54567BOZJ19 allows a remote, unauthenticated attacker to enable telnetd on the router via a crafted HTTP request.

The web interface on the RIGOL MSO5000 digital oscilloscope with firmware 00.01.03.00.03 allows remote attackers to change the admin password via a zero-length pass0 to the webcontrol changepwd.cgi application, i.e., the entered password only needs to match the first zero characters of the saved password.

A Broken Access Control vulnerability in the D-Link DSL-2680 web administration interface (Firmware EU_1.03) allows an attacker to download the configuration (binary file) settings by submitting a rom-0 GET request without being authenticated on the admin interface.

A vulnerability has been identified in RUGGEDCOM CROSSBOW (All versions < V5.4). The affected applications accept unauthenticated file write messages. An unauthenticated remote attacker could write arbitrary files to the affected application's file system.

includes/class-coming-soon-creator.php in the igniteup plugin through 3.4 for WordPress allows unauthenticated arbitrary file deletion.

A vulnerability in the configuration import utility of Cisco Integrated Management Controller (IMC) could allow an unauthenticated, remote attacker to have write access and upload arbitrary data to the filesystem. The vulnerability is due to a failure to delete temporarily uploaded files. An attacker could exploit this vulnerability by crafting a malicious file and uploading it to the affected device. An exploit could allow the attacker to fill up the filesystem or upload malicious scripts.

A security vulnerability exists in the Zingbox Inspector versions 1.280 and earlier, where authentication is not required when binding the Inspector instance to a different customer tenant.

A vulnerability, which was classified as critical, has been found in 20120630 Novel-Plus up to 0e156c04b4b7ce0563bef6c97af4476fcda8f160. This issue affects the function addCrawlSource of the file novel-crawl/src/main/java/com/java2nb/novel/controller/CrawlController.java. The manipulation leads to missing authentication. The attack may be initiated remotely. The exploit has been disclosed to the public and may be used. The vendor was contacted early about this disclosure but did not respond in any way.

Tad Uploader edit book list function is vulnerable to authorization bypass, thus remote attackers can use the function to amend the folder names in the book list without logging in.

The Noise protocol implementation suffers from weakened cryptographic security after encrypting 2^64 messages, and a potential denial of service attack. After 2^64 (~18.4 quintillion) messages are encrypted with the Encrypt function, the nonce counter will wrap around, causing multiple messages to be encrypted with the same key and nonce. In a separate issue, the Decrypt function increments the nonce state even when it fails to decrypt a message. If an attacker can provide an invalid input to the Decrypt function, this will cause the nonce state to desynchronize between the peers, resulting in a failure to encrypt all subsequent messages.

An issue was discovered in Joomla! before 3.9.5. The "refresh list of helpsites" endpoint of com_users lacks access checks, allowing calls from unauthenticated users.

ESPHome is a system to control the ESP8266/ESP32. Anyone with web_server enabled and HTTP basic auth configured on version 2021.9.1 or older is vulnerable to an issue in which `web_server` allows over-the-air (OTA) updates without checking user defined basic auth username & password. This issue is patched in version 2021.9.2. As a workaround, one may disable or remove `web_server`.

The udpServerSys service in Petwant PF-103 firmware 4.22.2.42 and Petalk AI 3.2.2.30 allows remote attackers to initiate firmware upgrades and alter device settings.

The mem0 1.0.0 server lacks authentication and authorization controls for its memory management API endpoints. Critical functions such as updating memory records (PUT /memories/{memory_id}) are exposed without any verification of the requester's identity or permissions. A remote attacker can exploit this by sending unauthenticated requests to modify, overwrite, or delete arbitrary memory records, leading to unauthorized data manipulation and potential data loss.

FreeSWITCH is a Software Defined Telecom Stack enabling the digital transformation from proprietary telecom switches to a software implementation that runs on any commodity hardware. Prior to version 1.10.7, FreeSWITCH does not authenticate SIP MESSAGE requests, leading to spam and message spoofing. By default, SIP requests of the type MESSAGE (RFC 3428) are not authenticated in the affected versions of FreeSWITCH. MESSAGE requests are relayed to SIP user agents registered with the FreeSWITCH server without requiring any authentication. Although this behaviour can be changed by setting the `auth-messages` parameter to `true`, it is not the default setting. Abuse of this security issue allows attackers to send SIP MESSAGE messages to any SIP user agent that is registered with the server without requiring authentication. Additionally, since no authentication is required, chat messages can be spoofed to appear to come from trusted entities. Therefore, abuse can lead to spam and enable social engineering, phishing and similar attacks. This issue is patched in version 1.10.7. Maintainers recommend that this SIP message type is authenticated by default so that FreeSWITCH administrators do not need to be explicitly set the `auth-messages` parameter. When following such a recommendation, a new parameter can be introduced to explicitly disable authentication.

An authentication bypass vulnerability has been found in Repox, which allows a remote user to send a specially crafted POST request, due to the lack of any authentication method, resulting in the alteration or creation of users.

The ADB (formerly Pirelli Broadband Solutions) P.DGA4001N router with firmware PDG_TEF_SP_4.06L.6, and possibly other routers, uses "1236790" and the MAC address to generate the WPA key.

The D-Link DIR-816 A2 1.11 router only checks the random token when authorizing a goform request. An attacker can get this token from dir_login.asp and use an API URL /goform/form2userconfig.cgi to edit the system account without authentication.

The D-Link DIR-816 A2 1.11 router only checks the random token when authorizing a goform request. An attacker can get this token from dir_login.asp and use an API URL /goform/setSysAdm to edit the web or system account without authentication.

A Missing Authentication for Critical Function vulnerability in B. Braun SpaceCom2 prior to 012U000062 allows a remote attacker to reconfigure the device from an unknown source because of lack of authentication on proprietary networking commands.

The web administration server in Solar-Log 500 before 2.8.2 Build 52 does not require authentication, which allows remote attackers to gain administrative privileges by connecting to the server. As a result, the attacker can modify configuration files and change the system status. Fixed with 3.0.0-60 11.10.2013 for SL 200, 500, 1000 / not existing for SL 250, 300, 1200, 2000, SL 50 Gateway, SL Base.

VDSM and libvirt in Red Hat Enterprise Virtualization Hypervisor (aka RHEV-H) 7-7.x before 7-7.2-20151119.0 and 6-6.x before 6-6.7-20151117.0 as packaged in Red Hat Enterprise Virtualization before 3.5.6 when VSDM is run with -spice disable-ticketing and a VM is suspended and then restored, allows remote attackers to log in without authentication via unspecified vectors.

There is an arbitrary password modification vulnerability in a D-LINK DSL-2888A router product. An attacker can use this vulnerability to modify the password of the admin user without authorization.

A vulnerability has been identified in SICAM GridEdge (Classic) (All versions < V2.6.6). The affected application does not require authenticated access for privileged functions. This could allow an unauthenticated attacker to change data of a user, such as credentials, in case that user's id is known.

Honeywell Experion PKS Safety Manager through 2022-05-06 has Missing Authentication for a Critical Function. According to FSCT-2022-0051, there is a Honeywell Experion PKS Safety Manager multiple proprietary protocols with unauthenticated functionality issue. The affected components are characterized as: Honeywell Experion TCP (51000/TCP), Safety Builder (51010/TCP). The potential impact is: Manipulate controller state, Manipulate controller configuration, Manipulate controller logic, Manipulate controller files, Manipulate IO. The Honeywell Experion PKS Distributed Control System (DCS) Safety Manager utilizes several proprietary protocols for a wide variety of functionality, including process data acquisition, controller steering and configuration management. These protocols include: Experion TCP (51000/TCP) and Safety Builder (51010/TCP). None of these protocols have any authentication features, allowing any attacker capable of communicating with the ports in question to invoke (a subset of) desired functionality. There is no authentication functionality on the protocols in question. An attacker capable of invoking the protocols' functionalities could achieve a wide range of adverse impacts, including (but not limited to), the following: for Experion TCP (51000/TCP): Issue IO manipulation commands, Issue file read/write commands; and for Safety Builder (51010/TCP): Issue controller start/stop commands, Issue logic download/upload commands, Issue file read commands, Issue system time change commands. A mitigating factor with regards to some, but not all, of the above functionality is that these require the Safety Manager physical keyswitch to be in the right position.

IBM Sterling Partner Engagement Manager 6.1.2, 6.2.0, and 6.2.2 could allow a remote user to perform unauthorized actions due to improper authentication. IBM X-Force ID: 266896.

A remote unauthenticated attacker may be able to bypass authentication by utilizing a specific API route to execute arbitrary OS commands.