MantisBT before 1.3.20 and 2.22.1 allows Post Authentication Command Injection, leading to Remote Code Execution.

EyesOfNetwork 5.1 allows Remote Command Execution via shell metacharacters in the module/tool_all/ host field.

A command injection vulnerability exists in the Zingbox Inspector versions 1.286 and earlier, that allows for an authenticated user to execute arbitrary system commands in the CLI.

A vulnerability, which was classified as critical, was found in TOTOLINK EX1200L EN_V9.3.5u.6146_B20201023. This affects the function setDiagnosisCfg. The manipulation leads to os command injection. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. The identifier VDB-237513 was assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.

The traceroute function on the TP-Link TL-WR840N v4 router with firmware through 0.9.1 3.16 is vulnerable to remote code execution via a crafted payload in an IP address input field.

Dell SmartFabric Storage Software v1.4 (and earlier) contains an OS Command Injection Vulnerability in the restricted shell in SSH. An authenticated remote attacker could potentially exploit this vulnerability, leading to execute arbitrary commands.

Command injection in PAN-0S 9.0.2 and earlier may allow an authenticated attacker to gain access to a remote shell in PAN-OS, and potentially run with the escalated user’s permissions.

Vulnerability in the CommandPost, Collector, and Sensor components of Fidelis Network and Deception enables an attacker with user level access to the CLI to inject root level commands into the component and neighboring Fidelis components. The vulnerability is present in Fidelis Network and Deception versions prior to 9.3.7 and in version 9.4. Patches and updates are available to address this vulnerability.

In the "webupg" binary of D-Link DIR-825 G1, because of the lack of parameter verification, attackers can use "cmd" parameters to execute arbitrary system commands after obtaining authorization.

A vulnerability was reported in Lenovo Smart Camera X3, X5, and C2E that could allow command injection by setting a specially crafted network configuration. This vulnerability is the same as CNVD-2020-68652.

A improper neutralization of special elements used in an OS command ('OS Command Injection') in Fortinet FortiWLM version 8.6.1 and below allows attacker to execute unauthorized code or commands via crafted HTTP requests.

Magento Commerce versions 2.4.2 (and earlier), 2.4.2-p1 (and earlier) and 2.3.7 (and earlier) are affected by an XML Injection vulnerability in the Widgets Update Layout. An attacker with admin privileges can trigger a specially crafted script to achieve remote code execution.

Vulnerability in Fidelis Network and Deception CommandPost enables authenticated command injection through the web interface. The vulnerability could allow a specially crafted HTTP request to execute system commands on the CommandPost and return results in an HTTP response in an authenticated session. The vulnerability is present in Fidelis Network and Deception versions prior to 9.3.7 and in version 9.4. Patches and updates are available to address this vulnerability.

A Improper neutralization of special elements used in a command ('Command Injection') in Fortinet FortiWeb version 6.3.13 and below allows attacker to execute unauthorized code or commands via crafted HTTP requests

Magento Commerce versions 2.4.2 (and earlier), 2.4.2-p1 (and earlier) and 2.3.7 (and earlier) are affected by an Improper Neutralization of Special Elements Used In A Command via the Data collection endpoint. An attacker with admin privileges can upload a specially crafted file to achieve remote code execution.

An issue in YeaLinkSIP-T19P-E2 v.53.84.0.15 allows a remote privileged attacker to execute arbitrary code via a crafted request the ping function of the diagnostic component.

Multiple command injection vulnerabilities in the command line interpreter of FortiWeb versions 6.4.1, 6.4.0, 6.3.0 through 6.3.15, 6.2.0 through 6.2.6, and 6.1.0 through 6.1.2 may allow an authenticated attacker to execute arbitrary commands on the underlying system shell via specially crafted command arguments.

A vulnerability in the web-based management interface of Cisco Intersight Virtual Appliance could allow an authenticated, remote attacker to perform a command injection attack on an affected device. This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by using the web-based management interface to execute a command using crafted input. A successful exploit could allow the attacker to execute arbitrary commands using root-level privileges on an affected device.

A Remote Code Execution (RCE) issue in the addon CUx-Daemon 1.11a of the eQ-3 Homematic CCU-Firmware 2.35.16 until 2.45.6 allows remote authenticated attackers to execute system commands as root remotely via a simple HTTP request.

Multiple camera devices by UDP Technology, Geutebrück and other vendors are vulnerable to command injection, which may allow an attacker to remotely execute arbitrary code.

Multiple camera devices by UDP Technology, Geutebrück and other vendors are vulnerable to command injection, which may allow an attacker to remotely execute arbitrary code.

A command injection vulnerability has been reported to affect QNAP device running Media Streaming add-on. If exploited, this vulnerability allow remote attackers to run arbitrary commands. We have already fixed this vulnerability in the following versions of Media Streaming add-on: QTS 5.0.0: Media Streaming add-on 500.0.0.3 ( 2021/08/20 ) and later QTS 4.5.4: Media Streaming add-on 500.0.0.3 ( 2021/08/20 ) and later QTS 4.3.6: Media Streaming add-on 430.1.8.12 ( 2021/08/20 ) and later QTS 4.3.3: Media Streaming add-on 430.1.8.12 ( 2021/09/29 ) and later QuTS-Hero 5.0.0: Media Streaming add-on 500.0.0.3 ( 2021/08/20 ) and later

Multiple camera devices by UDP Technology, Geutebrück and other vendors are vulnerable to command injection, which may allow an attacker to remotely execute arbitrary code.

A remote arbitrary command execution vulnerability was discovered in Aruba ClearPass Policy Manager version(s): Prior to 6.10.0, 6.9.6 and 6.8.9. Aruba has released updates to ClearPass Policy Manager that address this security vulnerability.

Multiple camera devices by UDP Technology, Geutebrück and other vendors are vulnerable to command injection, which may allow an attacker to remotely execute arbitrary code.

A remote arbitrary command execution vulnerability was discovered in Aruba ClearPass Policy Manager version(s): Prior to 6.10.0, 6.9.6 and 6.8.9. Aruba has released updates to ClearPass Policy Manager that address this security vulnerability.

Multiple camera devices by UDP Technology, Geutebrück and other vendors are vulnerable to command injection, which may allow an attacker to remotely execute arbitrary code.

Zavio CF7500, CF7300, CF7201, CF7501, CB3211, CB3212, CB5220, CB6231, B8520, B8220, and CD321 IP Cameras with firmware version M2.1.6.05 has a command injection vulnerability in their implementation of their binaries and handling of network requests.

Multiple camera devices by UDP Technology, Geutebrück and other vendors are vulnerable to command injection, which may allow an attacker to remotely execute arbitrary code.

Multiple vulnerabilities in the Cisco ATA 190 Series Analog Telephone Adapter Software could allow an attacker to perform a command injection attack resulting in remote code execution or cause a denial of service (DoS) condition on an affected device. For more information about these vulnerabilities, see the Details section of this advisory.

In Bender/ebee Charge Controllers in multiple versions are prone to Command injection via Web interface. An authenticated attacker could enter shell commands into some input fields that are executed with root privileges.

A remote arbitrary command execution vulnerability was discovered in Aruba ClearPass Policy Manager version(s): Prior to 6.10.0, 6.9.6 and 6.8.9. Aruba has released updates to ClearPass Policy Manager that address this security vulnerability.

A remote arbitrary command execution vulnerability was discovered in Aruba ClearPass Policy Manager version(s): Prior to 6.10.0, 6.9.6 and 6.8.9. Aruba has released updates to ClearPass Policy Manager that address this security vulnerability.

A command injection vulnerability has been reported to affect QNAP device running QVR. If exploited, this vulnerability could allow remote attackers to run arbitrary commands. We have already fixed this vulnerability in the following versions of QVR: QVR 5.1.5 build 20210803 and later

Multiple camera devices by UDP Technology, Geutebrück and other vendors are vulnerable to command injection, which may allow an attacker to remotely execute arbitrary code.

Command injection in `main/lp/openoffice_presentation.class.php` in Chamilo LMS <= v1.11.24 allows users permitted to upload Learning Paths to obtain remote code execution via improper neutralisation of special characters.

In Weidmueller Industrial WLAN devices in multiple versions an exploitable command injection vulnerability exists in encrypted diagnostic script functionality of the devices. A specially crafted diagnostic script file can cause arbitrary busybox commands to be executed, resulting in remote control over the device. An attacker can send diagnostic while authenticated as a low privilege user to trigger this vulnerability.

There is remote authenticated OS command injection on TP-Link Archer C20i 0.9.1 3.2 v003a.0 Build 170221 Rel.55462n devices vie the X_TP_ExternalIPv6Address HTTP parameter, allowing a remote attacker to run arbitrary commands on the router with root privileges.

An issue was discovered on D-Link DIR-818LW devices with firmware 2.06betab01. There is a command injection in HNAP1 (exploitable with Authentication) via shell metacharacters in the Type field to SetWanSettings.

Gerapy is a distributed crawler management framework. Prior to version 0.9.9, an authenticated user could execute arbitrary commands. This issue is fixed in version 0.9.9. There are no known workarounds.

KLog Server through 2.4.1 allows authenticated command injection. async.php calls shell_exec() on the original value of the source parameter.

EyesOfNetwork eonweb through 5.3-11 allows Remote Command Execution (by authenticated users) via shell metacharacters in the nagios_path parameter to lilac/export.php, as demonstrated by %26%26+curl to insert an "&& curl" substring for the shell.

Command injection in `main/lp/openoffice_text_document.class.php` in Chamilo LMS <= v1.11.24 allows users permitted to upload Learning Paths to obtain remote code execution via improper neutralisation of special characters.

Command injection vulnerability in QSAN Storage Manager allows remote privileged users to execute arbitrary commands. Suggest contacting with QSAN and refer to recommendations in QSAN Document.

AdRem NetCrunch 10.6.0.4587 allows Remote Code Execution. In the NetCrunch web client, a read-only administrator can execute arbitrary code on the server running the NetCrunch server software.

Poddycast is a podcast app made with Electron. Prior to version 0.8.1, an attacker can create a podcast or episode with malicious characters and execute commands on the client machine. The application does not clean the HTML characters of the podcast information obtained from the Feed, which allows the injection of HTML and JS code (cross-site scripting). Being an application made in electron, cross-site scripting can be scaled to remote code execution, making it possible to execute commands on the machine where the application is running. The vulnerability is patched in Poddycast version 0.8.1.

In Weidmueller Industrial WLAN devices in multiple versions an exploitable command injection vulnerability exists in the iw_webs functionality. A specially crafted iw_serverip parameter can cause user input to be reflected in a subsequent iw_system call, resulting in remote control over the device. An attacker can send commands while authenticated as a low privilege user to trigger this vulnerability.

In Weidmueller Industrial WLAN devices in multiple versions an exploitable command injection vulnerability exists in the iw_webs functionality. A specially crafted diagnostic script file name can cause user input to be reflected in a subsequent iw_system call, resulting in remote control over the device. An attacker can send commands while authenticated as a low privilege user to trigger this vulnerability.

Vesta Control Panel (VestaCP) through 0.9.8-26 allows Command Injection via the schedule/backup Backup Listing Endpoint. The attacker must be able to create a crafted filename on the server, as demonstrated by an FTP session that renames .bash_logout to a .bash_logout' substring followed by shell metacharacters.