TRENDnet TEW-827DRU with firmware up to and including 2.04B03 contains a stack-based buffer overflow while returning an error message to the user about failure to resolve a hostname during a ping or traceroute attempt. This allows an authenticated user to execute arbitrary code. The exploit can be exercised on the local intranet or remotely if remote administration is enabled.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the key passwd in Routing RIP Settings.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the Private Port in Add Virtual Server.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the IP Address in Add Gaming Rule.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the TCP Ports To Open in Add Gaming Rule.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the IP Address in Add Virtual Server.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication). The command injection exists in the key ip_addr.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the UDP Ports To Open in Add Gaming Rule.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the action set_sta_enrollee_pin_5g and the key wps_sta_enrollee_pin.

A vulnerability, which was classified as critical, has been found in TRENDnet TEW-652BRP 3.04B01. This issue affects some unknown processing of the file get_set.ccp of the component Web Management Interface. The manipulation leads to command injection. The attack may be initiated remotely. The exploit has been disclosed to the public and may be used. The associated identifier of this vulnerability is VDB-219935.

Buffer overflow in apply.cgi on TRENDnet TEW-632BRP 1.010B32 and TEW-673GRU devices allows attackers to hijack the control flow to any attacker-specified location by crafting a POST request payload (with authentication).

TRENDnet TEW-673GRU v1.00b40 devices have an OS command injection vulnerability in the start_arpping function of the timer binary, which allows remote attackers to execute arbitrary commands via three parameters (dhcpd_start, dhcpd_end, and lan_ipaddr) passed to the apply.cgi binary through a POST request.

An issue was discovered on D-Link DIR-825 Rev.B 2.10 devices. They allow remote attackers to execute arbitrary commands via the dns_query_name parameter in a dns_query.cgi POST request. TRENDnet TEW-632BRP 1.010B32 is also affected.

A vulnerability was found in TRENDnet TEW-815DAP 1.0.2.0. It has been classified as critical. This affects the function do_setNTP of the component POST Request Handler. The manipulation of the argument NtpDstStart/NtpDstEnd leads to command injection. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. The associated identifier of this vulnerability is VDB-252123. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.

Trendnet AC2600 TEW-827DRU version 2.08B01 is vulnerable to command injection. The system log functionality of the firmware allows for command injection as root by supplying a malformed parameter.

A vulnerability was detected in TRENDnet TEW-800MB 1.0.1.0. Affected by this vulnerability is the function sub_F934  of the file NTPSyncWithHost.cgi. The manipulation results in command injection. The attack may be launched remotely. The exploit is now public and may be used. The vendor was contacted early about this disclosure but did not respond in any way.

Trendnet AC2600 TEW-827DRU version 2.08B01 contains a command injection vulnerability in the smb functionality of the device. The username parameter used when configuring smb functionality for the device is vulnerable to command injection as root.

A security vulnerability has been detected in TRENDnet TEW-800MB 1.0.1.0. Affected is the function do_setWizard_asp of the file /goform/wizardset of the component Management Interface. The manipulation of the argument WizardConfigured leads to command injection. The attack may be initiated remotely. The exploit has been disclosed publicly and may be used. The vendor was contacted early about this disclosure but did not respond in any way.

TRENDnet TEW-827DRU devices through 2.06B04 contain multiple command injections in apply.cgi via the action send_log_email with the key auth_acname (or auth_passwd), allowing an authenticated user to run arbitrary commands on the device.

TRENDnet TEW-827DRU devices through 2.06B04 contain multiple command injections in apply.cgi via the action pppoe_connect, ru_pppoe_connect, or dhcp_connect with the key wan_ifname (or wan0_dns), allowing an authenticated user to run arbitrary commands on the device.

An issue was discovered on D-Link DIR-825 Rev.B 2.10 devices. They allow remote attackers to execute arbitrary commands via the date parameter in a system_time.cgi POST request. TRENDnet TEW-632BRP 1.010B32 is also affected.

An issue was discovered on D-Link DIR-825 Rev.B 2.10 devices. They allow remote attackers to execute arbitrary commands via the wps_sta_enrollee_pin parameter in a set_sta_enrollee_pin.cgi POST request. TRENDnet TEW-632BRP 1.010B32 is also affected.

Undocumented TELNET service in TRENDnet TEW-691GR and TEW-692GR when a web page named backdoor contains an HTML parameter of password and a value of j78G¬DFdg_24Mhw3.

An access control issue in TrendNet TV-IP572PI v1.0 allows unauthenticated attackers to access sensitive system information.

TRENDnet TEW-751DR v1.03B03, TEW-752DRU v1.03B01, and TEW733GR v1.03B01 devices allow authentication bypass via an AUTHORIZED_GROUP=1 value, as demonstrated by a request for getcfg.php.

Trendnet TEW733GR v1.03B01 contains a Static Default Credential vulnerability in /etc/init0.d/S80telnetd.sh.

The ping tool in multiple D-Link and TRENDnet devices allow remote attackers to execute arbitrary code via the ping_addr parameter to ping.ccp.

TRENDnet TS-S402 has a backdoor to enable TELNET.

Trendnet AC2600 TEW-827DRU version 2.08B01 does not have sufficient protections for the UART functionality. A malicious actor with physical access to the device is able to connect to the UART port via a serial connection. No username or password is required and the user is given a root shell with full control of the device.

A remote code execution vulnerability exists in Microsoft Exchange software when the software fails to properly handle objects in memory, aka 'Microsoft Exchange Memory Corruption Vulnerability'.

In Apache Zeppelin prior to 0.8.0 the cron scheduler was enabled by default and could allow users to run paragraphs as other users without authentication.

prosody before versions 0.10.2, 0.9.14 is vulnerable to an Authentication Bypass. Prosody did not verify that the virtual host associated with a user session remained the same across stream restarts. A user may authenticate to XMPP host A and migrate their authenticated session to XMPP host B of the same Prosody instance.

A vulnerability in the role-based resource checking functionality of the Cisco Unified Computing System (UCS) Director could allow an authenticated, remote attacker to view unauthorized information for any virtual machine in the UCS Director end-user portal and perform any permitted operations on any virtual machine. The permitted operations can be configured for the end user on the virtual machines with either of the following settings: The virtual machine is associated to a Virtual Data Center (VDC) that has an end user self-service policy attached to the VDC. The end user role has VM Management Actions settings configured under User Permissions. This is a global configuration, so all the virtual machines visible in the end-user portal will have the VM management actions available. The vulnerability is due to improper user authentication checks. An attacker could exploit this vulnerability by logging in to the UCS Director with a modified username and valid password. A successful exploit could allow the attacker to gain visibility into and perform actions against all virtual machines in the UCS Director end-user portal of the affected system. This vulnerability affects Cisco Unified Computing System (UCS) Director releases 6.0 and 6.5 prior to patch 3 that are in a default configuration. Cisco Bug IDs: CSCvh53501.

An issue was discovered on Vera VeraEdge 1.7.19 and Veralite 1.7.481 devices. The device provides a web user interface that allows a user to manage the device. As a part of the functionality the device allows a user to install applications written in the Lua programming language. Also the interface allows any user to write his/her application in the Lua language. However, this functionality is not protected by authentication and this allows an attacker to run arbitrary Lua code on the device. The POST request is forwarded to LuaUPNP daemon on the device. This binary handles the received Lua code in the function "LU::JobHandler_LuaUPnP::RunLua(LU::JobHandler_LuaUPnP *__hidden this, LU::UPnPActionWrapper *)". The value in the "code" parameter is then passed to the function "LU::LuaInterface::RunCode(char const*)" which actually loads the Lua engine and runs the code.

Authentication vulnerability found in Dahua NVR models NVR50XX, NVR52XX, NVR54XX, NVR58XX with software before DH_NVR5xxx_Eng_P_V2.616.0000.0.R.20171102. Attacker could exploit this vulnerability to gain access to additional operations by means of forging json message.

The FusionSphere OpenStack V100R006C00SPC102(NFV) has an improper authentication vulnerability. Due to improper authentication on one port, an authenticated, remote attacker may exploit the vulnerability to execute more operations by send a crafted rest message.

The FusionSphere OpenStack V100R006C00SPC102(NFV) has an improper authentication vulnerability. Due to improper authentication on one port, an authenticated, remote attacker may exploit the vulnerability to execute more operations by send a crafted rest message.

Insufficient security checks exist in the recovery procedure used by the Foscam C1 Indoor HD Camera running application firmware 2.52.2.43. A HTTP request can allow for a user to perform a firmware upgrade using a crafted image. Before any firmware upgrades in this image are flashed to the device, binaries as well as arguments to shell commands contained in the image are executed with elevated privileges.

It was found that there were no permission checks performed in the Distributed Fork plugin before and including 1.5.0 for Jenkins that provides the dist-fork CLI command beyond the basic check for Overall/Read permission, allowing anyone with that permission to run arbitrary shell commands on all connected nodes.

Datalogic AV7000 Linear barcode scanner all versions prior to 4.6.0.0 is vulnerable to authentication bypass, which may allow an attacker to remotely execute arbitrary code.

Siemens RUGGEDCOM ROX I (all versions) allow an authenticated user to bypass access restrictions in the web interface at port 10000/TCP to obtain privileged file system access or change configuration settings.

A Trusted RFC connection in SAP KERNEL 32NUC, SAP KERNEL 32Unicode, SAP KERNEL 64NUC, SAP KERNEL 64Unicode 7.21, 7.21EXT, 7.22, 7.22EXT; SAP KERNEL from 7.21 to 7.22, 7.45, 7.49, can be established to a different client or a different user on the same system, although no explicit Trusted/Trusting Relation to the same system has been defined.

In the Macally WIFISD2-2A82 Media and Travel Router 2.000.010, the Guest user is able to reset its own password. This process has a vulnerability which can be used to take over the administrator account and results in shell access. As the admin user may read the /etc/shadow file, the password hashes of each user (including root) can be dumped. The root hash can be cracked easily which results in a complete system compromise.

A vulnerability has been identified in the management interface of Citrix NetScaler Application Delivery Controller (ADC) and NetScaler Gateway 10.1 before build 135.18, 10.5 before build 66.9, 10.5e before build 60.7010.e, 11.0 before build 70.16, 11.1 before build 55.13, and 12.0 before build 53.13 (except for build 41.24) that, if exploited, could allow an attacker with access to the NetScaler management interface to gain administrative access to the appliance.

Huawei iBMC V200R002C60 have an authentication bypass vulnerability. A remote attacker with low privilege may craft specific messages to upload authentication certificate to the affected products. Due to improper validation of the upload authority, successful exploit may cause privilege elevation.

VMware Horizon DaaS (7.x before 8.0.0) contains a broken authentication vulnerability that may allow an attacker to bypass two-factor authentication. Note: In order to exploit this issue, an attacker must have a legitimate account on Horizon DaaS.

In Zulip Server before 1.7.1, on a server with multiple realms, a vulnerability in the invitation system lets an authorized user of one realm on the server create a user account on any other realm.

IBM Security QRadar SIEM 7.2 and 7.3 could allow a user to bypass authentication which could lead to code execution. IBM X-Force ID: 138824.

A vulnerability has been identified in Firmware variant PROFINET IO for EN100 Ethernet module : All versions < V1.04.01; Firmware variant Modbus TCP for EN100 Ethernet module : All versions < V1.11.00; Firmware variant DNP3 TCP for EN100 Ethernet module : All versions < V1.03; Firmware variant IEC 104 for EN100 Ethernet module : All versions < V1.21; EN100 Ethernet module included in SIPROTEC Merging Unit 6MU80 : All versions < 1.02.02; SIPROTEC 7SJ686 : All versions < V 4.87; SIPROTEC 7UT686 : All versions < V 4.02; SIPROTEC 7SD686 : All versions < V 4.05; SIPROTEC 7SJ66 : All versions < V 4.30. Attackers with network access to the device's web interface (port 80/tcp) could possibly circumvent authentication and perform certain administrative operations. A legitimate user must be logged into the web interface for the attack to be successful.

There is an authentication bypass vulnerability in some Huawei servers. A remote attacker with low privilege may bypass the authentication by some special operations. Due to insufficient authentication, an attacker may exploit the vulnerability to get some sensitive information and high-level users' privilege.