An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the IP Address in Add Virtual Server.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the action set_sta_enrollee_pin_5g and the key wps_sta_enrollee_pin.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the key passwd in Routing RIP Settings.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the TCP Ports To Open in Add Gaming Rule.

A vulnerability was found in TRENDnet TEW-815DAP 1.0.2.0. It has been classified as critical. This affects the function do_setNTP of the component POST Request Handler. The manipulation of the argument NtpDstStart/NtpDstEnd leads to command injection. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. The associated identifier of this vulnerability is VDB-252123. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the UDP Ports To Open in Add Gaming Rule.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication). The command injection exists in the key ip_addr.

An issue was discovered in TRENDnet TEW-827DRU firmware before 2.05B11. There is a command injection in apply.cgi (exploitable with authentication) via the IP Address in Add Gaming Rule.

TRENDnet TEW-827DRU with firmware up to and including 2.04B03 contains a stack-based buffer overflow while returning an error message to the user about failure to resolve a hostname during a ping or traceroute attempt. This allows an authenticated user to execute arbitrary code. The exploit can be exercised on the local intranet or remotely if remote administration is enabled.

Buffer overflow in apply.cgi on TRENDnet TEW-632BRP 1.010B32 and TEW-673GRU devices allows attackers to hijack the control flow to any attacker-specified location by crafting a POST request payload (with authentication).

A vulnerability, which was classified as critical, has been found in TRENDnet TEW-652BRP 3.04B01. This issue affects some unknown processing of the file get_set.ccp of the component Web Management Interface. The manipulation leads to command injection. The attack may be initiated remotely. The exploit has been disclosed to the public and may be used. The associated identifier of this vulnerability is VDB-219935.

TRENDnet TEW-827DRU devices through 2.06B04 contain a stack-based buffer overflow in the ssi binary. The overflow allows an authenticated user to execute arbitrary code by POSTing to apply.cgi via the action auto_up_fw (or auto_up_lp) with a sufficiently long update_file_name key.

TRENDnet TEW-827DRU devices through 2.06B04 contain a stack-based buffer overflow in the ssi binary. The overflow allows an authenticated user to execute arbitrary code by POSTing to apply.cgi via the action set_sta_enrollee_pin_wifi1 (or set_sta_enrollee_pin_wifi0) with a sufficiently long wps_sta_enrollee_pin key.

TRENDnet TEW-827DRU devices through 2.06B04 contain a stack-based buffer overflow in the ssi binary. The overflow allows an authenticated user to execute arbitrary code by POSTing to apply.cgi via the action st_dev_connect, st_dev_disconnect, or st_dev_rconnect with a sufficiently long wan_type key.

TRENDnet TEW-827DRU devices through 2.06B04 contain a stack-based buffer overflow in the ssi binary. The overflow allows an authenticated user to execute arbitrary code by POSTing to apply.cgi via the action wifi_captive_portal_login with a sufficiently long REMOTE_ADDR key.

TRENDnet TEW-827DRU devices through 2.06B04 contain a stack-based buffer overflow in the ssi binary. The overflow allows an authenticated user to execute arbitrary code by POSTing to apply.cgi via the action kick_ban_wifi_mac_allow with a sufficiently long qcawifi.wifi0_vap0.maclist key.

TRENDnet WiFi Baby Cam TV-IP743SIC has a password of admin for the backdoor root account.

TRENDnet TEW-812DRU router allows remote authenticated users to execute arbitrary commands via shell metacharacters in the (1) wan network prefix to internet/ipv6.asp; (2) remote port to adm/management.asp; (3) pptp username, (4) pptp password, (5) ip, (6) gateway, (7) l2tp username, or (8) l2tp password to internet/wan.asp; (9) NtpDstStart, (10) NtpDstEnd, or (11) NtpDstOffset to adm/time.asp; or (12) device url to adm/management.asp. NOTE: vectors 9, 10, and 11 can be exploited by unauthenticated remote attackers by leveraging CVE-2013-3098.

Trendnet AC2600 TEW-827DRU version 2.08B01 contains a command injection vulnerability in the smb functionality of the device. The username parameter used when configuring smb functionality for the device is vulnerable to command injection as root.

A vulnerability was found in TRENDnet TEW-800MB 1.0.1.0 and classified as critical. Affected by this issue is some unknown functionality of the component POST Request Handler. The manipulation of the argument DeviceURL leads to os command injection. The attack may be launched remotely. The exploit has been disclosed to the public and may be used. VDB-252122 is the identifier assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.

TRENDnet TEW-827DRU with firmware up to and including 2.04B03 contains multiple command injections when processing user input for the setup wizard, allowing an unauthenticated user to run arbitrary commands on the device. The vulnerability can be exercised on the local intranet or remotely if remote administration is enabled.

An issue was discovered on TRENDnet TEW-651BR 2.04B1, TEW-652BRP 3.04b01, and TEW-652BRU 1.00b12 devices. OS command injection occurs through the get_set.ccp lanHostCfg_HostName_1.1.1.0.0 parameter.

An issue was discovered in libremote_dbg.so on TRENDnet TV-IP1314PI 5.5.3 200714 devices. Filtering of debug information is mishandled during use of popen. Consequently, an attacker can bypass validation and execute a shell command.

TRENDnet TEW-673GRU v1.00b40 devices have an OS command injection vulnerability in the start_arpping function of the timer binary, which allows remote attackers to execute arbitrary commands via three parameters (dhcpd_start, dhcpd_end, and lan_ipaddr) passed to the apply.cgi binary through a POST request.

TRENDnet TEW755AP 1.13B01 was discovered to contain a command injection vulnerability via the sys_service parameter in the setup_wizard_mydlink (sub_4104B8) function.

TRENDnet TEW755AP 1.13B01 was discovered to contain a command injection vulnerability via the wps_sta_enrollee_pin parameter in the action set_sta_enrollee_pin_5g function.

An issue was found on TRENDnet TEW-831DR 1.0 601.130.1.1356 devices. An OS injection vulnerability exists within the web interface, allowing an attacker with valid credentials to execute arbitrary shell commands.

An issue was discovered on D-Link DIR-825 Rev.B 2.10 devices. They allow remote attackers to execute arbitrary commands via the wps_sta_enrollee_pin parameter in a set_sta_enrollee_pin.cgi POST request. TRENDnet TEW-632BRP 1.010B32 is also affected.

TRENDnet TEW-827DRU devices through 2.06B04 contain multiple command injections in apply.cgi via the action pppoe_connect, ru_pppoe_connect, or dhcp_connect with the key wan_ifname (or wan0_dns), allowing an authenticated user to run arbitrary commands on the device.

TRENDnet TEW-827DRU devices through 2.06B04 contain multiple command injections in apply.cgi via the action send_log_email with the key auth_acname (or auth_passwd), allowing an authenticated user to run arbitrary commands on the device.

An issue was discovered on D-Link DIR-825 Rev.B 2.10 devices. They allow remote attackers to execute arbitrary commands via the dns_query_name parameter in a dns_query.cgi POST request. TRENDnet TEW-632BRP 1.010B32 is also affected.

An issue was discovered on D-Link DIR-825 Rev.B 2.10 devices. They allow remote attackers to execute arbitrary commands via the date parameter in a system_time.cgi POST request. TRENDnet TEW-632BRP 1.010B32 is also affected.

Trendnet AC2600 TEW-827DRU version 2.08B01 is vulnerable to command injection. The system log functionality of the firmware allows for command injection as root by supplying a malformed parameter.

A command injection was identified on Barco ClickShare Base Unit devices with CSM-1 firmware before 1.7.0.3 and CSC-1 firmware before 1.10.0.10. An attacker with access to the product's web API can exploit this vulnerability to completely compromise the vulnerable device.

Tuleap before 9.7 allows command injection via the PhpWiki 1.3.10 SyntaxHighlighter plugin. This occurs in the Project Wiki component because the proc_open PHP function is used within PhpWiki before 1.5.5 with a syntax value in its first argument, and an authenticated Tuleap user can control this value, even with shell metacharacters, as demonstrated by a '<?plugin SyntaxHighlighter syntax="c;id"' line to execute the id command.

In Horde_Crypt before 2.7.6, as used in Horde Groupware Webmail Edition through 5.2.17, OS Command Injection can occur if the attacker is an authenticated Horde Webmail user, has PGP features enabled in their preferences, and attempts to encrypt an email addressed to a maliciously crafted email address.

Ruckus Networks Unleashed AP firmware releases before 200.6.10.1.x and Ruckus Networks Zone Director firmware releases 10.1.0.0.x, 9.10.2.0.x, 9.12.3.0.x, 9.13.3.0.x, 10.0.1.0.x or before contain authenticated Root Command Injection in the CLI that could allow authenticated valid users to execute privileged commands on the respective systems.

An issue was discovered in Trend Micro InterScan Messaging Security (Virtual Appliance) 9.1-1600. An authenticated user can execute a terminal command in the context of the web server user (which is root). Besides, the default installation of IMSVA comes with default administrator credentials. The saveCert.imss endpoint takes several user inputs and performs blacklisting. After that, it uses them as arguments to a predefined operating-system command without proper sanitization. However, because of an improper blacklisting rule, it's possible to inject arbitrary commands into it.

Ruckus Networks Solo APs firmware releases R110.x or before and Ruckus Networks SZ managed APs firmware releases R5.x or before contain authenticated Root Command Injection in the web-GUI that could allow authenticated valid users to execute privileged commands on the respective systems.

An exploitable command injection vulnerability exists in the iwwebs functionality of the Moxa AWK-3131A firmware version 1.13. A specially crafted diagnostic script file name can cause user input to be reflected in a subsequent iwsystem call, resulting in remote control over the device. An attacker can send commands while authenticated as a low privilege user to trigger this vulnerability.

In version 3.5 and prior of Cambium Networks ePMP firmware, a lack of input sanitation for certain parameters on the web management console allows any authenticated user (including the otherwise low-privilege readonly user) to inject shell meta-characters as part of a specially-crafted POST request to the get_chart function and run OS-level commands, effectively as root.

In Ubiquiti Networks EdgeSwitch X v1.1.0 and prior, an authenticated user can execute arbitrary shell commands over the SSH interface bypassing the CLI interface, which allow them to escalate privileges to root.

In the web management interface in Foscam C1 Indoor HD cameras with application firmware 2.52.2.37, a specially crafted HTTP request can allow for a user to inject arbitrary shell characters during NTP server configuration resulting in command injection. An attacker can simply send an HTTP request to the device to trigger this vulnerability.

In the web management interface in Foscam C1 Indoor HD cameras with application firmware 2.52.2.37, a specially crafted HTTP request can allow for a user to inject arbitrary data in the "msmtprc" configuration file resulting in command execution. An attacker can simply send an HTTP request to the device to trigger this vulnerability.

A vulnerability in Cisco WebEx Meetings Server could allow an authenticated, remote attacker to execute predetermined shell commands on other hosts. More Information: CSCuz03353. Known Affected Releases: 2.6.

An exploitable command injection vulnerability exists in the web management interface used by the Foscam C1 Indoor HD Camera running application firmware 2.52.2.37. A specially crafted HTTP request can allow for a user to inject arbitrary shell characters during account creation resulting in command injection. An attacker can simply send an HTTP request to the device to trigger this vulnerability.

Improper neutralization of special elements used in an OS command ('OS Command Injection') vulnerability in mail sending and receiving component in Synology Mail Station before 20211105-10315 allows remote authenticated users to execute arbitrary commands via unspecified vectors.

An exploitable command injection vulnerability exists in the web management interface used by the Foscam C1 Indoor HD Camera running application firmware 2.52.2.37. A specially crafted HTTP request can allow for a user to inject arbitrary shell characters during the SMTP configuration tests resulting in command execution

In the web management interface in Foscam C1 Indoor HD Camera running application firmware 2.52.2.37, a specially crafted HTTP request can allow for a user to inject arbitrary data in the "msmtprc" configuration file resulting in command execution. An attacker can simply send an HTTP request to the device to trigger this vulnerability.

An exploitable command injection vulnerability exists in the web management interface used by the Foscam C1 Indoor HD Camera running application firmware 2.52.2.37. A specially crafted HTTP request can allow for a user to inject arbitrary shell characters during account creation resulting in command injection. An attacker can simply send an HTTP request to the device to trigger this vulnerability.